Results 1 to 4 of 4

Thread: Eagletree Vector Dual Elevators

  1. #1
    Navigator
    Join Date
    Jun 2016
    Posts
    3

    Eagletree Vector Dual Elevators

    Hi guys, just wondering has anyone successfully setup dual elevator on the Vector with the remaining three channels still working correctly? (rudder, Aileron, throttle)
    I can get it working BUT I loose the rudder channel signal.
    If I revert back to the single elevator setup everything is fine again rudder is back working!
    I have set the dual elevator mix on my Futaba radio before connecting it to the Vector and have then gone through the RX Wizard using Sbus selecting second elevator option as I go through but when I get to the part that asks to move the rudder all the way left its not recognizing or getting a rudder signal.
    The rudder servo is locking to the left like it is receiving power but no signal command.
    I've connected the second elevator to Aux1 on the Vector outputs and rechecked all the cables and even went as far as doing a factor reset on the Vector.
    Do I need to sacrifice my rudder if I want to use dual elevators using eagletree vector?
    Any help on this would be appreciated.

  2. #2
    Co-Pilot Håvard Støre's Avatar
    Join Date
    Jul 2014
    Location
    Norway, West coast
    Posts
    1,737
    Is this for a Ritewing boomer?

  3. #3
    Navigator
    Join Date
    Jun 2016
    Posts
    3
    No, it for a MFD Mini Crosswind.
    I just got it working so for anyone looking dual setup on traditional plane or similar using the eagletree vector you need to:
    1-Set the dual elevator mix on the Radio
    2- Connect second elevator to Aux1 on Vector outputs
    3-Re Run the Vector RC wizard but DO NOT select 2nd elevator option as you make your way through the wizard
    (this is where I went wrong... manual states you must!)
    4-Happy days dual elevators working.

  4. #4
    Co-Pilot Håvard Støre's Avatar
    Join Date
    Jul 2014
    Location
    Norway, West coast
    Posts
    1,737
    Well done buddy:-)

Similar Threads

  1. skylark AAT and eagletree Vector OSD
    By Catfly in forum SkylarkFPV
    Replies: 0
    Last Post: 15th May 2015, 06:07 PM
  2. eagletree vector yaw troubles
    By gkyle840 in forum OSDs & Flight Controllers
    Replies: 0
    Last Post: 18th December 2014, 10:17 PM
  3. New Eagletree Vector issues
    By ghostofSiRhC in forum Eagle Tree Systems
    Replies: 5
    Last Post: 23rd June 2014, 10:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •