www.immersionrc.com

Results 1 to 3 of 3

Thread: 12ch

  1. #1
    Navigator
    Join Date
    Nov 2018
    Posts
    12

    Question 12ch

    I have a EzUHF 8 Channel Receiver and EzUHF transmitter connected at Futaba T14SG.

    I want use more then 8 channel in ppm. I set Tx and Rx to 12CH and last firmware, but the channel 9,10,etc don't work.

    What can I do?

    Thank you

  2. #2
    Navigator
    Join Date
    May 2013
    Location
    Australia
    Posts
    139
    Is the radio set to output 12 chsnnels

  3. #3
    Navigator
    Join Date
    Aug 2013
    Location
    South Australia
    Posts
    298
    You need to go into the "ezUHF advanced" tab in the app and change the RX and then the TX to 12 ch mode. You will then also need to make sure the PPM count is set to 12. power them both down afterwards and re-bind them and it should work.
    Impulse Alien, TBS Disco, Tek Sumo, S800, VAS Wraith, Skysurfer

Similar Threads

  1. Futaba 14Sg + Ezuhf ( 12ch )
    By skyshoot in forum ImmersionRC
    Replies: 5
    Last Post: 27th March 2017, 11:35 PM
  2. Replies: 2
    Last Post: 7th February 2016, 02:17 PM
  3. Ezuhf 12ch howto
    By Rampa in forum ImmersionRC Support
    Replies: 1
    Last Post: 22nd April 2014, 12:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •