Results 1 to 3 of 3

Thread: TBS Crossfire not working with Micro Vector

  1. #1

    TBS Crossfire not working with Micro Vector

    I can't get crossfire to work with the micro vector....every time I run the wizard, keep saying it doesn't recognize switches, can't go any further with the setup. If anyone has any advice it would be very much appreciated........

  2. #2
    mostly is the problem in not right output signal. First look at XF transmitter if you have right input (at display should be something like "12ch PPM"). Then you have to setup one of receiver outputs to right sum signal - I do use mostly s.bus. Then you should have no problem with wizard.


  3. #3

    tbs crossfire

    thanks Jan.,,,,I switch to a sbus receiver and having no problem with wizard....

Similar Threads

  1. Gemini with BF 3.0 - Crossfire Micro is Not working
    By harryhirsch in forum Team-Black Sheep
    Replies: 0
    Last Post: 12th September 2018, 12:33 PM
  2. Replies: 3
    Last Post: 17th April 2018, 06:26 PM
  3. TBS Crossfire / Crossfire micro with Frsky X7s
    By eagle56 in forum Team-Black Sheep
    Replies: 0
    Last Post: 29th December 2017, 09:19 PM
  4. Vector with Droid Planner and TBS micro crossfire
    By Marty McFly in forum Eagle Tree Systems
    Replies: 0
    Last Post: 10th September 2017, 11:22 AM
  5. Crossfire Micro V2
    By slowgto in forum TBS Support
    Replies: 1
    Last Post: 19th October 2016, 12:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts