www.immersionrc.com

Results 1 to 2 of 2

Thread: rapidFIRE video issues

  1. #1
    Navigator
    Join Date
    Apr 2019
    Posts
    1

    rapidFIRE video issues

    I have a rapidFIRE receiver on Fatshark HD0 goggles.

    Everthing works normally on most quads. I recently got a BabyHawk R 3 inch quad. On this quad the video seems normal than all of a sudden goes inverse and starts scrolling across the screen. Here is an example:

    .

    You can see the bad behavior at about 50 seconds into the video. I tried viewing with other receivers and don't see the problem.

    The store where I bought my gear suggested to try switching from rapidFIRE to legacy mode and it seems to work, but I haven't tested much.

    Has anyone seen this behavior before? Any recommendations?

  2. #2
    Navigator
    Join Date
    Jun 2018
    Posts
    16
    I have seen the exact thing on one of my Tiny Whoops. I'm not sure what the cause is, but I think it's something to do with the whoop combo board. That's the only quad it's happened with. There is actually 3 settings on the Rapid fire. #1, #2, and Legacy. When I was having the problem, I switched to #2 and never had it happen again. If I switched back to #1, it would happen again. The only visible difference with #2 is that you don't get the RapidFire OSD on the screen.
    I have since swapped some FC boards around and did some firmware updates, and I don't see that issue any more....even on #1.
    So, perhaps make sure your Rapidfire and babyhawk FC are all flashed to the newest versions?

    KevinB

Similar Threads

  1. Fatshark HD3 Core Rapidfire
    By schugabe in forum Fat Shark R/C Vision Systems
    Replies: 2
    Last Post: 21st March 2019, 03:10 AM
  2. RapidFire bad signal
    By InFlames in forum RC TECH
    Replies: 0
    Last Post: 17th February 2019, 01:06 PM
  3. RapidFIRE Batch2?
    By hoenens in forum ImmersionRC Support
    Replies: 1
    Last Post: 18th January 2019, 02:11 AM
  4. Dominator HD2 problem with Rapidfire
    By longtooth in forum Fat Shark R/C Vision Systems
    Replies: 2
    Last Post: 19th November 2018, 03:31 PM
  5. RAPIDFIRE 1.1.1
    By WILBUR FPV in forum ImmersionRC
    Replies: 3
    Last Post: 6th October 2018, 08:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •