Results 1 to 3 of 3

Thread: Tango Battery Low Alert

  1. #1
    Navigator
    Join Date
    Aug 2016
    Posts
    25

    Tango Battery Low Alert

    When flying a whoop with a Betafpv F4 1s Brushless Flight controller (Frsky + OSD) after around 30-45 seconds of flight the Tango starts beeping briefly the display on the screen shows Battery Low. Clearly this is an error because I can go on to fly for at least 2 minutes. Assuming because I'm running a single cell stick the voltage drop is setting the battery alarm off. I have tried going into the Power/ Battery tab in Betaflight and lowering min voltage alert to 1 to no avail. Is there a way to disable this alarm? I have tried turning off Telemetry in Betaflight configuration tab as well as the two battery alert sliders in the configuration tab and nojoy. Is there a way to disable that alarm of the tx? Cheers

  2. #2
    Navigator
    Join Date
    Dec 2016
    Posts
    7
    Did you ever figure this out?

  3. #3
    Navigator
    Join Date
    Aug 2016
    Posts
    25
    Quote Originally Posted by Vito600rr View Post
    Did you ever figure this out?
    Set the board to D8 instead of D16.

Similar Threads

  1. In Search of.... Basic Low Battery Alert!
    By Irrok in forum RC TECH
    Replies: 3
    Last Post: 18th September 2015, 03:21 PM
  2. Alert!
    By hoggdoc in forum PILOT'S CHECK IN
    Replies: 1
    Last Post: 23rd October 2014, 10:05 AM
  3. Noob Alert
    By Bearhugger70 in forum PILOT'S CHECK IN
    Replies: 16
    Last Post: 2nd April 2014, 12:26 PM
  4. Skylark trace IV low rssi alert
    By marcelokron in forum SkylarkFPV
    Replies: 2
    Last Post: 8th January 2014, 12:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •