www.immersionrc.com

Results 1 to 2 of 2

Thread: Tramp hv loosing video

  1. #1
    Navigator raycray1's Avatar
    Join Date
    Nov 2013
    Location
    Indiana
    Posts
    12

    Tramp hv loosing video

    I am using a bardwell f4 board and have the tramp powered directly to the 4s lipo. My problem is I have great video until I power up the motors and get very slight waves in the video and as soon as I give more throttle the video goes to static. After that I can scan with my rapid fire module and there is no output from the tramp it is still powered. The only way to get it to transmit is to use the wand or push buttons on tramp.
    If anyone has any suggestions they would be greatly appreciated. Also this is the third tramp I have tried.
    Thanks in advance.

  2. #2
    Navigator
    Join Date
    Mar 2019
    Posts
    2
    Similar issue here. I can fly for some time and the video is fine. When I change the lipo I do not get video anymore.
    Can be "repaired" by going to the menu via button... not a nice solution...

    Also bardwell F4 board but tramp hv connected powered by FC.

Similar Threads

  1. Tramp HV Video Transmitter smells burnt
    By Firepower in forum ImmersionRC
    Replies: 4
    Last Post: 17th November 2018, 10:59 AM
  2. Replies: 2
    Last Post: 2nd June 2018, 04:48 AM
  3. Tramp HV keeps resetting in flight loosing video signal
    By Vortexnoob in forum ImmersionRC Support
    Replies: 1
    Last Post: 1st June 2018, 02:59 AM
  4. Tramp No Video but camera OSD is displayed
    By RollsFPV in forum ImmersionRC Support
    Replies: 1
    Last Post: 22nd February 2018, 04:22 AM
  5. Vortex 250 Pro: Replacing stock video Tx module with new Tramp HV video Tx
    By Brotato Chip in forum Immersion Vortex Support
    Replies: 19
    Last Post: 20th August 2017, 05:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •