Hi Everyone,

Two years ago I started buying parts for my racing drone and I made a post about my build and asked for advice on it. Shortly afterward we had a few financial issues arise and I was unable to finish buying parts.
I am looking to finish building this now and I am thinking there are probably some dated areas of my build.
My previous post was here https://fpvlab.com/forums/showthread...h-QAV210-Build

I have posted the parts from that post below. Regardless of the parts that say (purchased)- if there is something better/different I should do- I would appreciate your advice. Thank you.

QAV210 CHARPU Frame (Purchased)
4x Lumenier Mini 20A ESC w/ SimonK Autoshot (Purchased)
4x Lumenier 2206-11 2350Kv Motor
1300mAh 4s 60c LiPo
Gemfan 5x4.5 Nylon Glass Fiber Propeller
Abusemark Naze32 FunFly Controller (Purchased)
Lumenier CM-650 Mini 650TVL Camera
FrSky Taranis X9D Plus 2.4GHz ACCST Radio
FrSky D4R-II 4ch 2.4Ghz ACCST Receiver (Purchased)
Lumenier TX5G6R Mini 600mW 5.8GHz Transmitter
IBCrazy 1566 5.8GHz Antennas
B6SC Charger
FatShark Dominators v3 Goggles
OSDoge OSD for the Naze32
3D Printed Motor Guards from fpv-flightclub (Purchased)
3D Printed d4r-ii Mount from fpv-flightclub (Purchased)
[COLOR=#333333]3D Printed QAV210 Sliders from fpv-flightclub (Purchased)

Other Misc Connectors, Parts, and Tools
RC Breakout Cable for Naze32 Rev6 (Purchased)
XT60 Pow[/B][B]er Connectors (Purchased)
6mm Wire Mesh Guard (Purchased)
10mm Wire Mesh Guard (Purchased)
Dupont Jumper Wire Connectors (Purchased)
1x2, 1x3, & 1x4 Dupont Connector Housings (Purchased)
Loctite Threadlocker (Purchased)
Servo Extension Cord Cables (Purchased)
5mm Lock Nuts - Right & Left Threads (Purchased)
Non-magnetic Forceps (Purchased)
Dupont Terminal Ratchet Crimper (Purchased)