Results 1 to 2 of 2

Thread: Tbs crossfire rssi with pixhawk mav link and rc in simotaneously?

  1. #1
    Navigator
    Join Date
    Jan 2015
    Location
    Milwaukee, Wi, USA
    Posts
    434

    Tbs crossfire rssi with pixhawk mav link and rc in simotaneously?

    I have my pixhawk connected to my crossfire diversity rx via mavlink which gives me only 8 rc channels, my question is, could I sent rssi/LQ out ppm on ch 9 and then route it to the ch 2 pins and connect them to the rc in on pixhawk? That way channels 1 thru 8 work thru mavlink but I can still then use ch9 for rssi/lq. I'm hoping someone can give me the answers so I don't have to experiment... Also if that works then I could also use ch 10 thru 12 for accessories in the future..

    So so is it possible to use mavlink and use ch 1 thru 8 via rc over mavlink, but then still use ch 9 thru 12 at all? Or at least use 1 channel to inject rssi into the pixhawk rc in? Or would that confuse pixhawk? Or are channels above ch 8 just dead when mavlink is selected? I understand only 8 ch can go thru mavlink because of its limitations, but does crossfire still alloch 9 thru 12 to be used via its physical outputs? I'm going to experiment either way, but any advice is always nice...

    thanks guys

  2. #2
    Navigator cracymarc's Avatar
    Join Date
    Jul 2014
    Location
    Germany
    Posts
    200
    Might a bit to late- channel 8 isbthr highest channel transmitted by rcovermavlink.
    The other channels could be injected by sbus(just set the other output to sbus) or used a real pem outputs on the receiver

    Gesendet von meinem EML-L29 mit Tapatalk

Similar Threads

  1. Crossfire + Pixhawk
    By iwcai in forum Team-Black Sheep
    Replies: 160
    Last Post: 7th April 2019, 10:21 AM
  2. Crossfire telemetry from pixhawk not working
    By silverburn in forum TBS Support
    Replies: 39
    Last Post: 7th May 2018, 02:48 PM
  3. TBS crossfire micro rx pixhawk telemetry
    By elang in forum Team-Black Sheep
    Replies: 2
    Last Post: 13th November 2016, 04:20 AM
  4. Crossfire link quality
    By marcus621000 in forum Team-Black Sheep
    Replies: 2
    Last Post: 14th February 2016, 05:21 AM
  5. Crossfire Pixhawk question
    By qbert in forum OSDs & Flight Controllers
    Replies: 0
    Last Post: 3rd January 2016, 05:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •