Results 1 to 3 of 3

Thread: Tiny OSD III

  1. #1
    Navigator Mowgli's Avatar
    Join Date
    Jun 2016
    Location
    Denmark, Skovlunde
    Posts
    18

    Tiny OSD III

    Firmware 2.9
    Wired according to the manual.
    The Camera/Vtx is getting power through the Balancer on the flight battery (2200 25c) (Plane is pulling a max of 10 amps)
    Camera Runcam Swift Mini
    VTX : Eachine TX801

    Problem
    When I apply throttle the OSD info starts to flicker and as I apply more throttle it disappears totally, and I get interference on the video.
    When I throttle back the osd info comes back (Sometimes it does not).
    If no Throttle then the video image and OSD is solid.

    When I leave out the OSD and power the camera and vtx through the Balancer, there is no interference at all - it's rock solid.

    Any suggestions?
    Last edited by Mowgli; 3rd April 2018 at 04:25 AM.

  2. #2
    Navigator Mowgli's Avatar
    Join Date
    Jun 2016
    Location
    Denmark, Skovlunde
    Posts
    18
    Could it be a power problem?
    It's in a ZOHD Nano talon with a 30 amp ESC/ 1 amp BEC.

  3. #3
    I'm a little late to the party here, but yes, it's probably a power problem. I had the same thing happen on a 450 heli that I set up for fpv. Turned out that the bec was inadequate.

Similar Threads

  1. tiny osd gps i need help
    By mbtsm in forum OSDs & Flight Controllers
    Replies: 0
    Last Post: 22nd August 2014, 06:50 AM
  2. Replies: 6
    Last Post: 13th November 2013, 12:46 PM
  3. HK Tiny OSD III
    By mrrf900 in forum SkylarkFPV
    Replies: 0
    Last Post: 19th November 2012, 08:06 PM
  4. USB for Tiny OSD III
    By durangoflyer in forum SkylarkFPV
    Replies: 1
    Last Post: 10th July 2012, 03:54 PM
  5. Tiny III ???
    By JBeloncik in forum SkylarkFPV
    Replies: 7
    Last Post: 8th April 2012, 09:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •