I have been flying the vortex for a couple of weeks now and no matter what preset tune I use , when i go above half throttle or especially a punch out it sounds like the motors are rapidly cutting out, it is not a smooth acceleration and it continues as long as you are throttled up. Props are good no visible problems and have re run the wizard. No firmware upgrades have been performed.
Thanks
What batt.?
4s Tattu 1300 mah 75c
What does your voltage say while full throttle?
on a fresh pack it'll usually go to 14 , but even when I'm hovering at around half throttle and I go to increase throttle slightly you'll hear and see the quad kind of shutter, not nearly as bad as Full Throttle but you still notice it.
Can you try puting on 4 brand new props. And also check of your motor shafts aren't bend.
installed 4 new 5040 bull nose props with same results. ckd the shafts and found no negative results. Installed new props and used a ruler to ck the track of the blades.
Thanks
Can you pop the top plate off and make sure the FC is still screwed down properly? And bottom connectors are in fully and not skewed?
Velvety smooth drone pilot for hire
Flight controller secured and connections are good.
Deleted
Last edited by hodges42; 13th January 2018 at 09:54 PM.
Posting Permissions
Reply With Quote