1.3 VTX and Video

[Cary Pond]

Installed a 1.3 VTX on the Stratosurfer with Vector. Have a 800 mw transmitter on plane and a 5.8 Fatshark repeater on the ground station.

Whenever I give it throttle, I see horizontal lines (engine noise) on the monitor-goggles. Did install a high pass filter on the 1.3 receiver antennae and ferrite ring on the VTX cable. Would a LC filter installed installed on the video cable of the vector clean this up ?

This is my first 1.3 system and looking to get further out.

[j5coat]

Installed a 1.3 VTX on the Stratosurfer with Vector. Have a 800 mw transmitter on plane and a 5.8 Fatshark repeater on the ground station.

Whenever I give it throttle, I see horizontal lines (engine noise) on the monitor-goggles. Did install a high pass filter on the 1.3 receiver antennae and ferrite ring on the VTX cable. Would a LC filter installed installed on the video cable of the vector clean this up ?

This is my first 1.3 system and looking to get further out.

Yes I would add an LLC filter, should clean that up for you.

Sent from my XT1254 using Tapatalk

[Cary Pond]

Yes I would add an LLC filter, should clean that up for you.

Sent from my XT1254 using Tapatalk

Did it and it helps !! Put these LC filters on my wings and planes and helps a lot. Good investment !!