Ok still cant figure it out. On basic f3 boards the servo(s) connects to motor pins 1,2 (or updated versions motor pins 5, 6). But the powercube has a dedicated servo port.

BUT I CANT FIND THE PIN NUMBER ASSIGNED TO IT.

Ive been in the cli tabs and resource shows the motor pins are C06 to B15. If tried all the free pins (A00,A01 etc) but cant find the dedicated servo pin port. The led strip is on A06, so I tried all around it (A05, A07 etc). But no luck

Any ideas


I have considered forgetting the servo port and just solder a wire to motor 5 pin (A00). But doing this I still dont know which PHYSICAL PIN is the motor 5 pin (calibre uses motors pins connected directly to the esc bourd once stacked.