Vortex 250 pro - Level modes don't work anymore

[Mavericksan]

Today I wanted to try my good old Vortex 250 pro.
The mode was set to Angle, I armed and immediately the bird rolled over.

I tried Acro Mode and everything was fine.

At home in BF I wanted to calibrate the Gyro, but doesn't work. In BF setup the flight level is wired - see attached screenshot.
In the motors test section of BF, both motors 3 and 4 spin at 1500-1600 after arming - in Angle and Horizon mode.
When I arm in Acro mode, all motors spin around min_throttle....

What's wrong with the level modes?
Why it won't calibrate?

[ImmersionRC Support]

Pls calibrate your 250 from withing the osd menu and see if that fixes it.

[Mavericksan]

Pls calibrate your 250 from withing the osd menu and see if that fixes it.

I flashed OSD and BF, reseted tx and at least at the bench it works.

Gesendet von meinem SM-T800 mit Tapatalk

[Mavericksan]

Today I wanted to try my good old Vortex 250 pro.
The mode was set to Angle, I armed and immediately the bird rolled over.

I tried Acro Mode and everything was fine.

At home in BF I wanted to calibrate the Gyro, but doesn't work. In BF setup the flight level is wired - see attached screenshot.
In the motors test section of BF, both motors 3 and 4 spin at 1500-1600 after arming - in Angle and Horizon mode.
When I arm in Acro mode, all motors spin around min_throttle....

What's wrong with the level modes?
Why it won't calibrate?

Before this happened, I changed PIDs via OSD in the field.

Hope this is not a software glitch in OSD that after saving the tunes within OSD the level modes won't work.

I will test this afternoon....

Gesendet von meinem SM-G935F mit Tapatalk