image
Results 1 to 6 of 6

Thread: Power Supply Question

  1. #1
    Navigator
    Join Date
    Aug 2016
    Posts
    7

    Power Supply Question

    Is a 2s (7.4 volts) 1300 mAh lipo enough power for a camera and 600 mw vtx immersion rc? I get no picture just static with my goggles.

  2. #2
    Pilot JCLs's Avatar
    Join Date
    Dec 2013
    Location
    Houston, TX
    Posts
    1,043
    Need you to explain setup. If you look up specs on the tx it will work on 2-6 cell batteries so it should be fine. You need to look up specs on camera. Then you need to see if freq on tx same as on your goggles.


    Sent from my iPad using Tapatalk

  3. #3
    Co-Pilot Pushjerk's Avatar
    Join Date
    Dec 2012
    Location
    PNW
    Posts
    1,582
    As JCLs stated, a picture of your setup will help mucho, as well as what gear You're running.

    Many if of the older cams run on 12V, but the newer cams have a much more forgiving range of input V.

    Post pics, names, specs, as much info as you can and you'll likely get sorted.
    "That aircraft is nothing but a bunch of spare parts flying in close formation!"

  4. #4
    Navigator Chasse's Avatar
    Join Date
    Jun 2015
    Location
    Pawleys Island, S.C.
    Posts
    124
    Everything light up? Cam and vtx? Probably just need to check channels. Don't take for granted that your goggles on ch 21 means 21 on the vtx! Read the sheets that come with the gear and match them up with the correct ghz values. Hope this helps.

    Sent from my N9518 using Tapatalk

  5. #5
    Navigator
    Join Date
    Aug 2016
    Posts
    7
    Thanks Chasse and all that replied. Got it sorted out. It was like you said Chasse goggles can be on ch 21 does not mean the 21 on the vtx is the same? Fooled around with dip switches on the vtx and got it to work with goggles. Really weird.

  6. #6
    Navigator
    Join Date
    Aug 2016
    Posts
    7
    Your are right Chasse goggles and vtx don't always match up. Got it sorted out fooling with the dip switches on the vtx. Very weird. Thanks to all who replied.

Similar Threads

  1. TBS Crossfire on Taranis x9 Power Supply Question
    By madchefmark in forum TBS Support
    Replies: 7
    Last Post: 21st October 2018, 02:29 PM
  2. Ironhorse 3.3GHz power supply question
    By Fyathyrio in forum IFR - Video Link Discussion
    Replies: 0
    Last Post: 11th June 2016, 09:59 PM
  3. Power leds from filterd balance lead TS power supply??
    By Hattrickmwf in forum Fat Shark R/C Vision Systems
    Replies: 0
    Last Post: 29th June 2015, 11:31 PM
  4. Fatshark 250MW VTX - Power supply question
    By skareb in forum ImmersionRC
    Replies: 2
    Last Post: 13th June 2015, 02:12 PM
  5. The really basic question about power supply to the Core
    By Finnk in forum Power Regulation / Power Distribution
    Replies: 9
    Last Post: 5th May 2014, 12:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •