Flashing Red on V2tx

[JonHogan]

I have had this for about 1.5yrs and all was setup and working properly, I haven't turned it on in about 6 months or so. I charged up everything and when I turned on the Dl all I get is a flashing red.

I tried to re-calibrate it per the instruction vid in the forum by holding down the [Bind] button and turning on power- just flashes red, no matter how long I hold it down.

DragonLink v2, Walkera Devo 12s
Using a Turnigy 3S 5k for power to DL.
It is mounted on the carry bar of the radio and both have been in carry case the whole time. (w/o batt on DL)?

Any help would be appreciated.

[JonHogan]

I think it may be the battery for the Walkera radio, not sure but it doesn't seem to charge completely, I ordered a new one and waiting on it to arrive.

Not sure about the old battery- could this be the reason? I can't find my multi-tester to test the battery- will right more when the new ones show up.

[vierfuffzig]

flashing red means no PPM - rather not a power-related issue. check cables / connectors. any chance to check your DL-Tx on a different rc-transmitter?

if all this to no avail contact mike via email: support@fpvpro.com

DL support is pretty 2nd to none..

cheers, basti.

[Racingmule]

Did you ever find out what the issue was? Mine has done the same.

[JonHogan]

Yes it was a front end load error Mike had me send it to him and he fixed it.

[Racingmule]

Thanks for your quick reply, i will email him.

[JonHogan]

No problem