Neither probably effect the ability to show rssi from the Crossfire, if I remember correctly, there us a specific rssi-crossfire setting on the osd menu.
Sent from my Pixel XL using Tapatalk
Neither probably effect the ability to show rssi from the Crossfire, if I remember correctly, there us a specific rssi-crossfire setting on the osd menu.
Sent from my Pixel XL using Tapatalk
W7STE
Thanks Steve for all the help everything is working as it should and I am getting the same RSSI readings in my OSD that you posted.
Glad it all worked for you, adds that extra bit of confidence when pushing the envelope.
Sent from my Pixel XL using Tapatalk
W7STE
Hey,
i finished a RotorX tbs vision. I bought a part here, a part there, waited a long time from tbs HK. I am looking for channel map of the tbs stack to Taranis, the built in buzzer can be moved on OSD NOR/REV I just wonder if there is a better way to know how the TBS stack channel numbers match Taranis channels.
i have done a opentx v2.2.1 update, Taranis tx and almost all my rx’s to latest firmwares. The vendetta and QQ190’s need done. I’m also doing a revamp of all my quads to be the same as in switch function/location, but not as far as the same rx id number ( might have problems at a Fpv meet )
i can move buzzer in beataflight/cleanflight(butterflight ?) on the Taranis, and in the tbs stacks OSD’. I can hook it up, change, look, I was hoping not do it 8 times (TBS stack OSD goes from channel 5 to 13)
Any informations about BST Support for Betaflight 3.4.0 ? Will my FPVision work with it?![]()
Hi! Please help me hook up my TBS fpvision layer to my new fc if possible.
I switched to a Helio Saping AIO FC and would like to use the tbs OSD
I use the BN-880 GPS, but have to clue how to wire it so the OSD gets the info or how to control the OSD with stick commands. I see there is a tx2 and rx2 pins on the fpvision board. Would that be what is used to control the board from another FC than the Colibri?
Not sure if this is possible at all. For sure you need to wire up the BST bus to the I2C Bus of your FC. Serial UART connection is AFAIK not required. But I'm not sure if all Betaflight targets include the BST/I2C drivers, or only the colibri one?
And take care, the FPVision Stack uses the Bolts for Battery Power. Many Flight controllers have all their mounting holes on ground, so mounting it as a stack without isolation will cause a direct battery short.
---> Let's make the Lab great again! <---
Caipi 2 / Strix Goblin / RVJet / Mini Race Wing / Mini Talon
Copters from Whoop to XClass