DragonLinkRC

Results 1 to 2 of 2

Thread: HELP, Why I can`t use channel 9+

  1. #1

    HELP, Why I can`t use channel 9+

    Hi to everyone.

    I`m trying to use output 5 and 6 in a dragon mini receiver. I`m using right now output 7 with s.bus to connect to a Vector and output 8 for RSSI analog signal so I want to connect a pan & tilt servos to Rx output 6 and 7 mapped with channel 8 and 9 in the Rx and in the Tx Futaba 14SG.

    Only works channel 8 trough output number 5, channel 9 and above trough output 6 didn't work. What I`m doing wrong?

    Click image for larger version. 

Name:	IMG_1701.JPG 
Views:	42 
Size:	217.0 KB 
ID:	74403Click image for larger version. 

Name:	IMG_1702.JPG 
Views:	46 
Size:	210.7 KB 
ID:	74404Click image for larger version. 

Name:	IMG_1704.JPG 
Views:	58 
Size:	403.3 KB 
ID:	74402

  2. #2
    I could fix this issue with Mike`s help. In the futaba 14sg transmitter you must enter in the trainer menu and select 14 ch instead 8 ch. As simple as that. Shame on me.

Similar Threads

  1. Where has channel 12 gone ????
    By Coyote in forum ImmersionRC
    Replies: 4
    Last Post: 1st September 2015, 03:46 AM
  2. 10 channel or 14 channel futaba
    By sleaper in forum RC TECH
    Replies: 6
    Last Post: 10th August 2015, 10:19 PM
  3. 2×tx same channel ?
    By fpv2soar in forum DIY
    Replies: 6
    Last Post: 23rd August 2014, 06:38 PM
  4. Channel 12?
    By Danr_657 in forum ImmersionRC
    Replies: 1
    Last Post: 13th March 2014, 03:01 PM
  5. PPM channel
    By mirmanchuck in forum DragonLink RC
    Replies: 1
    Last Post: 3rd March 2014, 11:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •