www.immersionrc.com

Results 1 to 3 of 3

Thread: Vortex 285 help with arming

  1. #1
    Forum Member
    Join Date
    May 2013
    Location
    Florida
    Posts
    1,086

    Vortex 285 help with arming

    Setting up a 285 for a buddy. Spektrum dx9 woth receiver is bound. Wizard seems to work and setup controls properly. Reversed channels that needed it. Motors won't arm. When I yaw right for a split second they moved but don't seem to arm ever. ??

    FW has been updated to current.


    Sent from my iPhone using Tapatalk

  2. #2
    Forum Member
    Join Date
    Apr 2016
    Posts
    1,943
    Could you put arming on a switch and try again?

  3. #3
    Forum Member
    Join Date
    Aug 2016
    Posts
    8
    How to accomplish this. I have mine and does not arm despite going through the tx setup and latest firmware. I have connected it to cleanflight and can see all sensor feedback but no response in the receiver tab (no movement of the sliders) I am using a DX6i with a PPM cable adapter to the serial receiver.

Similar Threads

  1. Vortex 250 RX and arming issues
    By Witterman in forum ImmersionRC Support
    Replies: 0
    Last Post: 8th August 2016, 08:48 PM
  2. Vortex 250 PRO arming problem
    By zemike in forum Immersion Vortex Support
    Replies: 5
    Last Post: 29th May 2016, 03:27 AM
  3. Vortex 285 - Arming
    By johnnylawn in forum Immersion Vortex Support
    Replies: 7
    Last Post: 4th May 2016, 08:11 AM
  4. Vortex Won't Arm after initial arming and sometimes won't shut off.
    By ubildit in forum Immersion Vortex Support
    Replies: 2
    Last Post: 25th October 2015, 10:28 PM
  5. Vortex Arming/Disarming USB Drivers Issues
    By Orgnoi1 in forum ImmersionRC
    Replies: 3
    Last Post: 26th May 2015, 10:53 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •