www.immersionrc.com

Results 1 to 3 of 3

Thread: Vortex - Taranis Dx9 plus- EzUhf 8ch rd - Erratic channels in CF

  1. #1
    Forum Member
    Join Date
    Jul 2015
    Posts
    4

    Vortex - Taranis Dx9 plus- EzUhf 8ch rd - Erratic channels in CF

    Dear all,

    With the above mentioned so I have problems getting a solid setup in Cleanflight.

    When I look at my channels, some keep moving erratically from 999 to 2000.

    I have tried to recreate a profile in the radio, but it didn't fix it.

    Also when I arm the quad, the motors rpm isn't stable. It goes up and down rapidly, and after about 15 seconds the quad tries to take off.

    I'm on Cleanflight 1.9 and latest firmware on the vortex and ezuhf rx and tx.

    Anyone know what might cause this?

    Thanks
    Sis

  2. #2
    ImmersionRC Support Guru swillhide's Avatar
    Join Date
    Aug 2012
    Location
    Mountain House, Ca
    Posts
    8,443
    Do you have the RX set to channel Mux on ch 1? or AKA in multicopter mode?

    Did you go thru the TX wizard thru the goggles?
    AMA # 1015480 HAM Callsign # Procrastinating..
    Futaba 9c w/Ezuhf /Skywalker 1880 or anything else that I can Lawn Dart.
    Retired: Disco(Sold), Skywalker 1900(Dirt Nap), Qav540g/Nazav2/Iosd mk2

  3. #3
    Forum Member
    Join Date
    Jul 2015
    Posts
    4
    Thanks! That was the solution.
    Highly appreciated

Similar Threads

  1. EzUHF distance/speed display erratic
    By Radius in forum ImmersionRC Support
    Replies: 9
    Last Post: 16th May 2017, 03:11 PM
  2. Vortex + Taranis Taranis X9D plus + X8R
    By FPVRom in forum ImmersionRC
    Replies: 10
    Last Post: 5th October 2015, 08:04 AM
  3. ImmersionRC Vortex - Erratic Behavior
    By gmoeller in forum ROTORCRAFT
    Replies: 3
    Last Post: 13th August 2015, 08:41 PM
  4. Erratic Channels on Receiver?
    By malibu73 in forum DragonLink RC
    Replies: 0
    Last Post: 27th April 2015, 07:55 PM
  5. Ezosd/Ezuhf erratic rssi readings at startup
    By Juan in forum ImmersionRC
    Replies: 3
    Last Post: 10th January 2013, 02:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •