Page 4 of 8 FirstFirst ... 23456 ... LastLast
Results 31 to 40 of 79

Thread: Tankito

  1. #31
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    Ok I will change PID_CONTROLLER=1.
    My board is aligned by default and my USB port is pointed towards the back (battery).
    What should set align_board_yaw = ? be if board is setup by default like mine?
    Last edited by orion3; 13th July 2015 at 03:13 PM.

  2. #32
    Flying Cinema Dev Team Leviathan's Avatar
    Join Date
    Aug 2014
    Posts
    199
    Ok that's the problem. Under configuration tab, change board align yaw to 0 and problem will be fixed. Let me know

  3. #33
    Flying Cinema Dev Team Leviathan's Avatar
    Join Date
    Aug 2014
    Posts
    199
    To 0 from 90

  4. #34
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    thanks, hope so.. will try it out in a bit and let you know.

  5. #35
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    Sorry, I still need to change pid_controller= from 0 to 1 right?

  6. #36
    Flying Cinema Dev Team Leviathan's Avatar
    Join Date
    Aug 2014
    Posts
    199
    With the pids you have, I would.

  7. #37
    Flying Cinema Dev Team
    Join Date
    Jun 2013
    Location
    San Diego, CA USA
    Posts
    309
    I finally played with video editing a little..


  8. #38
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    I like the video.

  9. #39
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    Tankito gods have been kind today and got mine tuned up ) I must say this is by far the best quad I flew.

    I can't make my ZMR250 fly the same way

  10. #40
    Navigator
    Join Date
    Oct 2014
    Location
    FL
    Posts
    151
    I have a question.

    I had to move my Naze32 board 90 degree clock wise so USBs on the left side of the quad when you look at it from behind in holding in front of yourself.

    I did change Board alignment from Roll 0 Pitch 10 Yaw 0 to
    Roll 0 Pitch 10 Yaw -90 and clicked Reset Z axis button so it shows offset -287 deg now.

    Is this a correct setup when board's usb connector is on the left side?
    Last edited by orion3; 16th July 2015 at 05:24 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •