Taranis X9D Plus, X8R and acro naze 32 problem

[panda]

Long story short.
I've setup my X8R reciever with a new acro naze 32 board by using the breakout cable. ground, + and signal to channel 1 and the rest of the signal cables to channel 2-7 respectively.

My taranis is binded to the X8R without any problems. However when I open cleanflight and click the reciever tab, the only bar that is moving is the yaw bar. I get no response whatsoever through the other channels.

In my Taranis the mixer setup is:
Channel 1 Throttle
Channel 2 Aileron
Channel 3 Elevator
Channel 4 Rudder


What am I doing wrong? :/

[xjet]

Have you set the NAZE channel ordering to to TAER mode? Under BaseFlight this used to be a CLI command, haven't used it with Cleanflight though. The default channel ordering (at least for Baseflight) is AETR. Also make sure that PPM is not enabled.

[panda]

The enabled features in cleanflight are:
VBAT MOTOR_STOP RX_PARALLEL_PWM

The channel order is set to TAER1234
Ive also set the Reciever Provider to SPEKTRUM1024

[Chuckdouglas]

Hey Panda did you make any progress with the x8r ?

I had a similar problem, now I have all TAER channels working but can't get the AUX channels going ..

[panda]

After reading forums, reddit and other places I came to the conclusion that the board was faulty so I contacted HK and they sent me a new one which works. I havent really had time to check all the features out, because of work, but I checked that TAER works I can check if my AUX channels work this weekend.

[sp3cialk]

Just asking to make sure. You did set your channels to switches in the Taranis right?