Results 1 to 4 of 4

Thread: TBS Core V1.2 pinout concern

  1. #1
    Navigator
    Join Date
    Jun 2013
    Location
    Milwaukee, WI
    Posts
    232

    TBS Core V1.2 pinout concern

    I tested my soldering of the TBS core with a continuity tester and it says the video and ground pins are connected is that normal or did I do a poor job soldering? Thanks

  2. #2
    Team BlackSheep Trappy's Avatar
    Join Date
    Feb 2011
    Posts
    10,901
    there's a 75 ohm resistance between them. You should not check for strict continuity but measure the ohms. Only if it's close to zero ohms resistance do you have an actual short.

  3. #3
    Navigator
    Join Date
    Jun 2013
    Location
    Milwaukee, WI
    Posts
    232
    OK but they will still for sure show continuity right?

  4. #4
    FPV Techanic RonSII's Avatar
    Join Date
    Dec 2011
    Location
    PNW USA
    Posts
    3,423
    ^^ They will show about 75 ohms of resistance... most multimeters with a 'continuity checker' function will beep at 300 ohms or less... so the DMM will still beep but like Trappy says you need to set the meter for 'ohms' and check to make sure there is not a direct short ( 0-2 ohms) it should read around 75 ohms.

Similar Threads

  1. SKYLARK AAT 5 pinout please!
    By Limeclouds in forum Skylark Support
    Replies: 3
    Last Post: 24th October 2014, 02:28 AM
  2. Replies: 2
    Last Post: 15th August 2014, 05:33 PM
  3. NAZA GPS pinout
    By Izord in forum OSDs & Flight Controllers
    Replies: 0
    Last Post: 16th July 2013, 02:01 PM
  4. ATT Other OSD pinout?
    By Blizzard1287 in forum SkylarkFPV
    Replies: 1
    Last Post: 10th July 2012, 10:23 PM
  5. A/V pinout
    By ror in forum ImmersionRC
    Replies: 2
    Last Post: 8th July 2012, 03:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •