Results 1 to 3 of 3

Thread: Naza M-V2, Error 29

  1. #1

    Naza M-V2, Error 29

    Naza M-V2 error 29?

    Someone had this problem?
    And know how to fix?
    Well-understood all calibrations and testing may have been tried
    before putting the video online ...

    Solution found a workaround:
    Disconnect cable ppm on the receiver before turning on the Discovery,
    and connect it later when the LED blinks orange.

    Thank you for your help!

  2. #2
    problem happened after a battery change ...
    No accident or shock, no worries for a month!

  3. #3
    Naza M-V2 Error 29 on TBS discovery, resolution:

    The receiver was back on default setting.
    Channel 1 must be on PPM muxed and not on PPM1.

    1) download software ImmersionRC:
    2) Follow this video
    3) Make binding procedure ImmersionRC EzUHF:
    4) Finally, make the Command Sticks Calibration on Naza M-V2 software.

Similar Threads

  1. DJI Naza setup error
    By JLN in forum OSDs & Flight Controllers
    Replies: 11
    Last Post: 13th August 2014, 09:19 PM
  2. DJI Naza setup error
    By JLN in forum IFR - Video Link Discussion
    Replies: 10
    Last Post: 20th July 2013, 10:51 PM
  3. A little trial and error
    By RTRyder in forum AIR SHOWS...
    Replies: 0
    Last Post: 5th September 2012, 06:05 PM
  4. OSDPro error
    By aalfaro in forum Eagle Tree Systems
    Replies: 2
    Last Post: 17th May 2012, 02:46 PM
  5. EZ OSD Showing GPS error
    By NICK TT in forum ImmersionRC
    Replies: 2
    Last Post: 14th November 2011, 05:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts