image

Search:

Type: Posts; User: Renn; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.44 seconds.

  1. Replies
    3
    Views
    246

    I replaced the internal battery as the old one...

    I replaced the internal battery as the old one was dead and not keeping the volatile memory alive
  2. Replies
    3
    Views
    246

    ublox M8N GPS battery backup and lock times

    Anyone have experience with this GPS? I recently discovered that my lock times are slow and I think its because of the battery on the puck. It takes minutes to acquire but when connected to iNAV on...
  3. Replies
    0
    Views
    908

    Insight HD transmission

    Anyone have experience with this?
    https://www.foxtechfpv.com/insight.html
  4. Replies
    750
    Views
    159,392

    Interested in getting one. But I am not clear on...

    Interested in getting one. But I am not clear on how to integrate this into my current system that incorporates a TBS Disco with APM 2.6 and a Futaba 7C transmitter. Where would I get a Futaba module?
  5. Thread: QAV400 or??

    by Renn
    Replies
    5
    Views
    624

    Disappointed with my TBS Discovery after...

    Disappointed with my TBS Discovery after switching over from a DJI 450. heavier and the CG is off. Thinking about going back to the DJI 450 and its symmetrical layout. Consider those points when...
  6. Replies
    2
    Views
    1,434

    Do these monitors blue screen?

    http://hobbywireless.com/video-monitors-c-179_52_66/43-fpv-tft-display-monitor-p-2296.html

    http://hobbywireless.com/video-monitors-c-179_52_66/35-fpv-tft-display-monitor-p-2295.html
  7. Replies
    299
    Views
    40,728

    FPV racing a sport? haha. dumb. This whole...

    FPV racing a sport? haha. dumb.
    This whole reference to FPV being soul is dumb too. Get over it.
  8. Replies
    0
    Views
    379

    carbon fiber props for Tiger AIR 350 motors?

    Any that can fit? Searched but confused on how it can mount. MN style - can I use the existing counter bullets ?
  9. Thread: Monoculars

    by Renn
    Replies
    3
    Views
    839

    Just got it and used it on one flight. Not very...

    Just got it and used it on one flight. Not very good detail as I expected. My gear is minimized now without a hulking 7" monitor on my transmitter with a phone for telemetry. I need to close one eye...
  10. Thread: Monoculars

    by Renn
    Replies
    3
    Views
    839

    Monoculars

    Anyone tried these?
    http://www.amazon.com/Koolertron-Glasses-Monocular-Resolution-Quadcopter/dp/B014J750H2
  11. Replies
    2
    Views
    911

    I have the one with a single button to change...

    I have the one with a single button to change channels from Banggood.
    I added a rather large heatsink to it prior to its first flight. Seems to be cool as the het sink is pointed towards the front...
  12. Replies
    2
    Views
    911

    Wrong input to Eachine 600mw Tx - damage?

    Tried my first flight with my Eachine 600 mw Tx and at first didn't get a signal - snow. Found out that I had the inputs to my minim OSD reversed so the input to the Eachine 600mw Tx was video in...
  13. Replies
    1
    Views
    650

    Minim OSD needs FTDI for initial install?

    Is the firmware already loaded on MinimOSD? I wired it up to my HK 2.7 pilot via instructions on Arducopter and get no OSD display. The board just blinks fast in red.
  14. WHere can I get information about towers in my...

    WHere can I get information about towers in my area?
  15. Replies
    11
    Views
    2,165

    Is this what DJI's Lightbridge tech built upon?

    Is this what DJI's Lightbridge tech built upon?
  16. Replies
    16
    Views
    10,721

    booo for poor product release

    booo for poor product release
  17. Thread: Phantom 3

    by Renn
    Replies
    9
    Views
    1,897

    anyone know the control and video downlink freqs...

    anyone know the control and video downlink freqs that Solo uses? It claims about half mile video
  18. Replies
    0
    Views
    639

    Lightbridge for FPV

    I primarily fly FPV and enjoy flying my TBS DIsco at some distance using 5.8 for video and a Futaba 7c on 2.4 I've been contemplating the DJI Lightbridge with my upgraded to V2 Naza Lite. Anyone out...
  19. Thread: TMotor Air 350

    by Renn
    Replies
    0
    Views
    479

    TMotor Air 350

    I bought this pack http://www.rctigermotor.com/html/2014/Combo_pack_0930/279.html and the motors have a reverse thread and regular thread, so if I wanted to through some other props on it where would...
  20. Replies
    18
    Views
    6,038

    Would I still need a traditional R/C transmitter...

    Would I still need a traditional R/C transmitter Rx for this thing? I have an older Naza Lite that I'd like to upgrade to V2 for this feature.
  21. TBS Core OSD accepts digital RSSI from Futaba 617?

    I plan to soldier a wire as described here: http://rcexplorer.se/diy/2011/01/lost-packet-indicator/ straight to the RSSI input to the TBS Core...anyone did this? Will it work? I understand the output...
  22. Replies
    2,310
    Views
    474,151

    transferring components from DJI 450

    Other than smaller motors and props, can I just use my Naza Lite FC and the DJI ESCs on the Spanky?
  23. Replies
    0
    Views
    446

    Vid Receiver near car roof?

    I wanted to have my monitor in my car and vid Rx on my windshield so I had a suction cup mount to the outside of my windshield, up high as I can. Then I had the monitor on my dash while I sit on the...
  24. Replies
    26
    Views
    6,526

    I used this and recently crapped on me. It can't...

    I used this and recently crapped on me. It can't seem to power either cam. I have a forward and downward facing cam....
  25. Replies
    2,310
    Views
    474,151

    very nice. I'm considering transferring parts...

    very nice. I'm considering transferring parts from my DJI 450 to this. It's obvious that I need smaller motors and props, would the Naza Lite work with this?
Results 1 to 25 of 71
Page 1 of 3 1 2 3