image

Search:

Type: Posts; User: ssb2005; Keyword(s):

Page 1 of 12 1 2 3 4

Search: Search took 0.17 seconds.

  1. Replies
    2
    Views
    577

    Super old firmware, it might be time to update it...

    Super old firmware, it might be time to update it / make sure both versions match.Then make sure they are both set to the same amount of RF channels or it can cause this type of glitching.
  2. Thread: 12ch

    by ssb2005
    Replies
    2
    Views
    241

    You need to go into the "ezUHF advanced" tab in...

    You need to go into the "ezUHF advanced" tab in the app and change the RX and then the TX to 12 ch mode. You will then also need to make sure the PPM count is set to 12. power them both down...
  3. Replies
    0
    Views
    63

    Crossfire, which one.

    HiI am looking at upgrading my control link from EzUHF to something with telemetry.I have been looking at the FrSky R9M but there seem to have been a few hiccups in its development.I so was looking...
  4. Make sure your radio is trimmed properly for 0...

    Make sure your radio is trimmed properly for 0 throttle or it won't arm
    also if you are using stick arm you may need to add some to your end point if it won't arm
  5. Replies
    0
    Views
    375

    Ranger Landing Gear

    Hi

    Does anyone know if the landing gear from the Ranger EX or similar will fit on a 757-7 (the 1600 version of the ranger)?


    Thanks

    Sam
  6. Replies
    3
    Views
    687

    I love the ranger, i have the 1600 though. It...

    I love the ranger, i have the 1600 though. It carries all sorts. What was yours doing?

    Have you tried looked at options such at the Talon or X-UAV clouds?
  7. Replies
    2,419
    Views
    503,687

    Sticky: New fixed with speed PR, 172.5 kph. S800 Sky...

    New fixed with speed PR, 172.5 kph.

    S800 Sky Shadow
    2600kv Samguk Series Wei Motor (Now melted :p)
    APS 6x4 prop
    50a ESC

    78602
  8. Replies
    7
    Views
    1,017

    Fit a lower KV motor and a bigger prop to the...

    Fit a lower KV motor and a bigger prop to the bixler and it will be much more silent. A 1400 or less kv motor and a 7 or 8 inch prop will do the trick
  9. Sometimes parts are omitted / changed in later...

    Sometimes parts are omitted / changed in later versions so I doubt its an issue as the rest of the board looks fine and the solder bridge looks like its meant to be there
  10. Replies
    2
    Views
    327

    Any details about what you are running? im...

    Any details about what you are running?

    im guessing something has come loose.
  11. Replies
    3
    Views
    417

    All good mate, Im glad you fixed it. Caps can be...

    All good mate, Im glad you fixed it. Caps can be beneficial on some builds to clean up the power.
  12. HOWTO :Adding Smart Port sensors to your FC

    Hi

    Some of you may find this handy. it shows how you can add a FrSKY smart port GPS in parallel with our flight controller telemetry. This makes it easier to find a downed quad as it will display...
  13. Replies
    1,539
    Views
    250,673

    Sticky: 78498 Coastal flight with the Sky Surfer...

    78498

    Coastal flight with the Sky Surfer
    Hero5 Black on 5s Time-lapse
  14. Replies
    2,419
    Views
    503,687

    Sticky: 78493 1116m Sky Surfer Eagle tree Vector...

    78493


    1116m
    Sky Surfer
    Eagle tree Vector
    5.8 Video
    EzUHF
  15. Replies
    2,419
    Views
    503,687

    Sticky: 78488 I dont have an OSD on this one but heres...

    78488

    I dont have an OSD on this one but heres the FRSky Telemetry Data, not sure if this allowed like this but here goes.

    153Kph

    S800 Sky Shadow
    Stock 30A ESC and Motor.
    5.5 x 4.5 APC...
  16. Replies
    3
    Views
    417

    looks like the parts inside the camera itself may...

    looks like the parts inside the camera itself may be vibrating, open up the camera and glue the board down or get a new camera. some of the PCB's are just stuck in there on poorly fitting plastic...
  17. Replies
    4
    Views
    493

    +1 for KISS

    +1 for KISS
  18. Replies
    6
    Views
    799

    The KISS FC flies amazing, you will love it.

    The KISS FC flies amazing, you will love it.
  19. Replies
    1
    Views
    711

    Oh that looks handy!

    Oh that looks handy!
  20. Replies
    1
    Views
    475

    I have used a standalone 32bit AlexMos board...

    I have used a standalone 32bit AlexMos board which works well, you can then assign extra channel inputs to it to move the Gimbal via the remote. I would go a genuine one as the clone ones do not...
  21. You should use a video distribution amplifier/...

    You should use a video distribution amplifier/ splitter otherwise it can degrade the signal and lose contrast etc. It will work without it between a few devices though.
  22. Replies
    1
    Views
    289

    Silly question but do you have the S port wire...

    Silly question but do you have the S port wire connected from your Receiver to the Flight Controller ? They did change colours between a couple of receiver models.
  23. Replies
    6
    Views
    799

    Thanks, I haven't noticed a reduction in flight...

    Thanks, I haven't noticed a reduction in flight time. Those little RGB LED's are usually only around a 60mA draw max each anyway so hardly any power.
  24. Replies
    4
    Views
    627

    How is the camera powered?

    How is the camera powered?
  25. Replies
    7
    Views
    817

    As above, could probably get it to work, but...

    As above, could probably get it to work, but loose the OSD. Will it work without the UART connected I wonder? and just not have remote channel adjust etc?
Results 1 to 25 of 300
Page 1 of 12 1 2 3 4