image

Search:

Type: Posts; User: noir522; Keyword(s):

Search: Search took 0.03 seconds.

  1. Ok solved. For the pitch servo (all I needed)...

    Ok solved.
    For the pitch servo (all I needed) the dedicated servo pins on the side of the colibri is B14 (motor 9 pin)

    1)connect servo to the side"servo" pin

    2)In the configuration tab enable...
  2. Just joking that would be Kaleesi. the calibre...

    Just joking that would be Kaleesi.

    the calibre is the the name of the actual flight controller board of the TBS powercube
  3. What you've never seem GAME OF THRONES??

    What you've never seem GAME OF THRONES??
  4. Thread: TBS POWERCUBE

    by noir522
    Replies
    1,751
    Views
    368,638

    77221 Ok this is where im at. I have my servo...

    77221
    Ok this is where im at. I have my servo pplugged into the port labeled "servo". I read on Betaflight wiki page that servo is assigned to pb15 (B15). So in the cli tab I assigned "resource...
  5. Thread: TBS POWERCUBE

    by noir522
    Replies
    1,751
    Views
    368,638

    I understand you, but before I can control the...

    I understand you, but before I can control the servo plugged into the servo port I have to tell betaflight where the port is (the pins address ).

    I can teach you how to drive a car, but if I cant...
  6. 101 views and not a single clue? C'mon, I thought...

    101 views and not a single clue? C'mon, I thought the TBS brainiacs haunted these boards.
    My mind is outta gas, I need someone to throw me a bone.

    I was thinking that if I went to the cli tab...
  7. How to set up gimbal / servo on TBS powercube calibre

    Ok still cant figure it out. On basic f3 boards the servo(s) connects to motor pins 1,2 (or updated versions motor pins 5, 6). But the powercube has a dedicated servo port.

    BUT I CANT FIND THE...
  8. Thread: TBS POWERCUBE

    by noir522
    Replies
    1,751
    Views
    368,638

    Ok im studying on the pinouts. In CLI servo...

    Ok im studying on the pinouts. In CLI servo assignment goes to what pin? I have it set to A01 but still nothing.

    Can someone verify what pin number is the calibre's dedicated sero port?

    ...
  9. Thread: TBS POWERCUBE

    by noir522
    Replies
    1,751
    Views
    368,638

    Ok For a gimbal / servo set up Im still...

    Ok For a gimbal / servo set up Im still experiencing issues.

    I attached the servo to the specified servo holes in the board and ticked servo tilt and cam stab in betaflight, set up my Taranis...
  10. Thread: TBS POWERCUBE

    by noir522
    Replies
    1,751
    Views
    368,638

    SERVOS AND GIMBAL QUESTION Where would one...

    SERVOS AND GIMBAL QUESTION

    Where would one attach/solder/plug is gimbal motors or servos. I know there is a dedicated servo port on the side of the board for tricopter servo, but would that work...
  11. Replies
    46
    Views
    13,539

    Ok let me do this one. Im a newb, but if your...

    Ok let me do this one. Im a newb, but if your left prop is perfectly parallel to the ground. And your right prop is tilted forward (albeit at a slight angle) then the quad will always naturally turn...
Results 1 to 11 of 11