image

Search:

Type: Posts; User: rdibley; Keyword(s):

Search: Search took 0.09 seconds.

  1. Replies
    42
    Views
    17,298

    I have the same setup as you, and I'm also seeing...

    I have the same setup as you, and I'm also seeing that same problem. (took me a while to figure it out) It doesn't matter if it goes to static between flights, so long as it starts up with a good...
  2. The manual states that the regulator can supply...

    The manual states that the regulator can supply up to 300mA. The camera will draw around 500mA when recording, and mine was set up to record when power is detected. So I assumed I damaged it by...
  3. ImmersionRC 5.8 GHz 600 mW failure - how to prevent in the future?

    I have an ImmersionRC 5.8 GHz 600 mW video transmitter installed in a 250 size racer quad. The transmitter is powered directly from the 3s flight pack. The antenna is connected to the transmitter...
  4. ImmersionRC 5.8GHz 600mW A/V Tx stopped working

    I have an ImmersionRC 5.8GHz 600mW A/V Tx that I used for about a week and then it just stopped working. I flew one day and it worked just fine. A few days later, I plugged in a battery on my quad...
  5. The heat sink is going to absorb a lot of heat...

    The heat sink is going to absorb a lot of heat and stay hot for a while after soldering, so I would remove the circuit board from the case if you do try soldering. The other issue you might run into...
  6. I couldn't find anything on the Arctic Silver web...

    I couldn't find anything on the Arctic Silver web page, but found other pages that say that both the Arctic Silver grease and the adhesive are around 8W/mK. According to this page:
    ...
  7. I'm not sure if you were asking me, but... I...

    I'm not sure if you were asking me, but...

    I soldered the copper pieces directly to the case. I then used Arctic Silver 5 between the copper pieces and the PC board and chip. I don't know if...
  8. I think you have a good point about using too...

    I think you have a good point about using too much arctic silver. I'm pretty sure it is conductive, and based on my past experiences using it on CPUs, I'm pretty sure I remember seeing it flow a...
  9. Lawmate 2.4GHz TX Tuning instructions - Additional suggestions

    In the Builds, Tuning & Modifications section, there are two different approaches to improving the cooling of the Lawmate VTx, one simple, one more challenging. I did the more challenging approach. ...
  10. Replies
    118
    Views
    36,376

    Lawmate 2.4gHz 500mw Tech

    In the Builds, Tuning & Modifications section, there are two different approaches to improving the cooling of the Lawmate VTx, one simple, one more challenging. I did the more challenging approach. ...
Results 1 to 10 of 10