image

Search:

Type: Posts; User: qavflyer; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.02 seconds.

  1. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    I have a TBS powercube with the V2 PDB (not...

    I have a TBS powercube with the V2 PDB (not FPVision) and upgraded V2 ESC's. I just purchased a new runcam with builtin OSD. Do you just hookup the white wire from the four pin TBS connector that...
  2. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Well I think I found my problem. I took apart...

    Well I think I found my problem. I took apart the TBS PowerCube and when I got down to the PDB/FPVision, I noticed something which would possibly cause my issue of a power dropout. I use nylon...
  3. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Thanks for the advise...I will check the XT60...

    Thanks for the advise...I will check the XT60 plug as you suggested. I have been able to duplicate this issue with the props off and just watching the quad on a table and the power never seems to go...
  4. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Anybody experience this problem? I have a...

    Anybody experience this problem? I have a FPVision Powercube with the 2-in-1 ESC's. When flying, it suddenly seems to reset/reboot in the air. It just shutdowns (all motors stop but electronics...
  5. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    I have had issues like yours in the past and here...

    I have had issues like yours in the past and here are the things I did/tried:
    - Make sure you are using the TBS Agent to load the BF firmware
    - Try older versions of BF firmware from the TBS Agent...
  6. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    You are right, it should not happen. I was going...

    You are right, it should not happen. I was going to unplug the battery but with a bottom mount it could have been even more of a problem. I guess I am going to study and practice the best way to...
  7. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Has anybody experienced this problem: I landed...

    Has anybody experienced this problem: I landed my quadcopter which has the Powercube FPVision 2-in-1 version and hit the kill switch as normal on my Spektrum radio. The motors stopped and all...
  8. Replies
    256
    Views
    68,180

    I am using the Spektrum Quad Race Serial Receiver...

    I am using the Spektrum Quad Race Serial Receiver with Diversity. So with this receiver, if I upgrade to BF 3.2 I will not be able to have the OSD controls that I currently have with the FPVision...
  9. Replies
    256
    Views
    68,180

    With Betaflight 3.2 Beta released and some of the...

    With Betaflight 3.2 Beta released and some of the talk I see in terms of issues with TBS OSD and BF 3.2, I was wondering if someone could provide some detail in terms of these issues or...
  10. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    With Betaflight 3.2 Beta released and some of the...

    With Betaflight 3.2 Beta released and some of the talk I see in terms of issues with TBS OSD and BF 3.2, I was wondering if someone could provide some detail in terms of these issues or...
  11. Replies
    256
    Views
    68,180

    Anybody have a problem with the FPVision OSD...

    Anybody have a problem with the FPVision OSD reporting wrong voltage readings? Today I was flying my quad and everything was good for 8 batteries. Then all of a sudden after switching to a new...
  12. Replies
    256
    Views
    68,180

    Thanks for the info. I had a feeling that this...

    Thanks for the info. I had a feeling that this is what was needed to do to get the camera menu. Thanks for confirming!
  13. Replies
    256
    Views
    68,180

    If you look in the OSD menu of the FPVision,...

    If you look in the OSD menu of the FPVision, there is a menu option for FPV Camera and under that menu option there is an option for Camera Audio which you can enable or disable SO I don't know what...
  14. Replies
    256
    Views
    68,180

    Ok, I finally got my build complete using the...

    Ok, I finally got my build complete using the FPVision. Everything seems to be working out okay except I don't get a camera menu under the FPVision OSD settings. I am using a RunCam Swift mini. ...
  15. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    UPDATE: Well after working on it a bit more I...

    UPDATE: Well after working on it a bit more I have found that the camera is bad. I took off the props, hooked up a battery and had the top plate off so I could move the camera around freely/playing...
  16. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Well, now I have a new problem which I can't...

    Well, now I have a new problem which I can't figure out. When the quad is sitting still and the motors are spinning, my video is fine. As soon as I give it some throttle, the video goes really...
  17. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Yes, not sure what fixed it but I changed out the...

    Yes, not sure what fixed it but I changed out the PDB and it seemed to hover fine in my basement but Motor #1 was still twitching a bit at idle. I increased the idle a bit but it still would...
  18. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Thanks for the advice/tips. I pretty much run...

    Thanks for the advice/tips. I pretty much run the stock PIDS (BF 3.1.7). I will check the balance and make sure the stack is centered and straight. It's mounted in a QAV-R frame and this frame...
  19. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Update: I replaced the PDB and was able to hover...

    Update: I replaced the PDB and was able to hover and move around a bit in my basement for almost a full battery with no issues. Motor #1 is still warmer than the others but not real hot. Hopefully...
  20. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Don't think it's screw length as it was happening...

    Don't think it's screw length as it was happening with the old emax motors also which have been on this quad for a long time. I used the new screws that came with the new Cobra motors that I just...
  21. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Having a problem with my Powercube and was...

    Having a problem with my Powercube and was wondering if anybody experienced my issue. I have upgraded it to V2 of the FC & PDB many months ago. I have recently upgraded it to V2 of the ESC's...
  22. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Has anybody done the upgrade to the new V2 ESC's...

    Has anybody done the upgrade to the new V2 ESC's with BLheli-S on their TBS Powercube? If so, what settings did you change in BetaFlight? Did you move to Multi-Shot and what settings did you...
  23. Thread: TBS POWERCUBE

    by qavflyer
    Replies
    1,751
    Views
    358,247

    Yup, just ONESHOT 125. TBS has released new...

    Yup, just ONESHOT 125. TBS has released new ESC's (V2) for the Powercube which will support BLHELI-S firmware and OneShot125/OneShot42/MultiShot protocols.
  24. Replies
    9
    Views
    4,915

    Yes, what I did was use the 4 nylon standoffs...

    Yes, what I did was use the 4 nylon standoffs that came with the QAV-Skitzo kit. You have to use 4 longer screws to go through the bottom plate into the mounts and then screw into the nylon...
  25. Replies
    9
    Views
    4,915

    New QAV-Skitzo build - need recommendations

    I plan on doing a new build based on the QAV-Skitzo frame. Here is what I am planning:

    Team Black Sheep FPVision (PBD, VTX & OSD)
    Team Black Sheep Colibri F3 FC
    Team Black Sheep Diagonal ESC...
Results 1 to 25 of 66
Page 1 of 3 1 2 3