image

Search:

Type: Posts; User: pinchio; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.03 seconds.

  1. Aux 6 on Cleanflight erractic movements uncontrollable

    So after updating Vortex Cleanflight Firmware to 1.9.1 I notice that Aux 6 is moving erratically while observing Receiver input on the Cleanflight software screen. Any ideas what might be going on?
    ...
  2. Replies
    5
    Views
    967

    Vortex and Gemfan 5x3 5030

    Anyone using a three bladed prop such as Gemfan 5x3 5030 on the Vortex?

    I'm looking at using a set of these I have kicking around....
  3. Replies
    39
    Views
    15,645

    Is the RSSI and telemetry downlink on the EzUHF...

    Is the RSSI and telemetry downlink on the EzUHF not considered two-way? Maybe I'm missing something, please elaborate.
  4. Hi @swillhide, I have been contacted by support...

    Hi @swillhide, I have been contacted by support today. They are asking me to send entire unit. The cost of shipping from Canada is over $40 with insurance and tracking. There is no mention of who...
  5. Vortex fell out of sky, broke arm, using all Immersion gear, am I able to get support

    Hi All,

    So I'm using all Immersion RC gear for my Vortex. I have an EzUHF transmitter and a EzUHF 8 channel lite receiver on the Vortex. Was flying clear line of sight yesterday about 200 feet out...
  6. Replies
    0
    Views
    382

    Curious: Vortex Channel Mapping Question

    My setup

    JR11X 2.4 radio with EzUHF external Tx.
    EzUHF 8 channel lite receiver
    Both are updated to 1.52 FW

    After binding successfully and initializing the Wizard sequence I noticed both my...
  7. Replies
    416
    Views
    81,655

    If I pre-order using the link on the first page...

    If I pre-order using the link on the first page will there be any additional costs for mandatory equipment (e.g. the transmitter module) that will be required? I need all in pricing for the pieces...
  8. Anyone else have input into what might be going...

    Anyone else have input into what might be going on here?
  9. Danger.... Problem with Orange R620x CPPM and failsafe not working

    Okay here is my test bed setup.

    JR11X radio
    Orange R620x CPPM receiver. Not the S-BUS variant.
    Flight pack battery to power the receiver
    A servo to observe the behaviour of the throttle...
  10. I'm not sure if there is such a setting in the JR...

    I'm not sure if there is such a setting in the JR 11X radio. If there is please tell me how.

    Thanks
  11. Here is a video that describes the problem I'm...

    Here is a video that describes the problem I'm having.


    https://youtu.be/FLda4PAoBvA
  12. Using Immersion Tools there is an option for Rx...

    Using Immersion Tools there is an option for Rx to be configured for Vortex. I used that option which I believe set the Channel 1 to PPM "muxed" if I remember correctly.
  13. Please I need your assistance. I have this brand...

    Please I need your assistance. I have this brand new Vortex and I can't run it without my radio setup working.

    JR 11x
    EzUHF 8 channel lite connected to Vortex on pin1
    EzUHF JR module installed...
  14. There is no setting in the JR11x to enable or...

    There is no setting in the JR11x to enable or disable PPM. Unless I'm missing something.
  15. Something interesting. It would appear that I am...

    Something interesting. It would appear that I am able to bind to the receiver but a couple of things are still not right. Firstly the power light on the module remains off. Secondly When I connect...
  16. JR Module binds to Rx but no response from Vortex. Help!

    Hello, just purchased a JR module for my JR11X. I removed the old module and inserted the EzUHF module. I attached the antenna and powered up the Tx. There are three short beeps a pause then 1 short...
  17. Replies
    2
    Views
    6,053

    Sticky: Will you offer a service that will print and ship...

    Will you offer a service that will print and ship our files we send to you at a reasonable cost?
  18. Replies
    4
    Views
    2,515

    When will you have the plastic crash kits in...

    When will you have the plastic crash kits in stock? How about 4s lipos in the >45C range that do not require one to sell a liver to afford? :-)
  19. Now I have a face to a name. Zoltan helped me...

    Now I have a face to a name. Zoltan helped me with a recent FatShark Attitude issue.
  20. Have you considered opening a location...

    Have you considered opening a location elsewhere... maybe near Ottawa?
  21. Thank you for taking the time to respond. Some...

    Thank you for taking the time to respond. Some vendors openly share their priority list with their loyal customers. Any chance that Immersion may share with your loyal customers here what that...
  22. This is interesting in deed. Strange that this is...

    This is interesting in deed. Strange that this is the first occurrence reported. Let's not jump to conclusions on what Immersion is concerned with. Interesting though that you three are using...
  23. Replies
    65
    Views
    13,678

    Yes that is great news. Can't wait for this...

    Yes that is great news. Can't wait for this capability. I wonder what the top priorities are for the roadmap? Some vendors (mostly open source) will allow customers to vote for top features and...
  24. Replies
    65
    Views
    13,678

    I also +1 on the request for RSSI support from...

    I also +1 on the request for RSSI support from other receivers besides EzUHF.

    Thanks
  25. Why is that, is there a proprietary format the...

    Why is that, is there a proprietary format the Vortex expects that only the EzUHF can provide?
Results 1 to 25 of 42
Page 1 of 2 1 2