image

Search:

Type: Posts; User: fpvguam; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.05 seconds.

  1. I am using the NexWave RF rx module for my...

    I am using the NexWave RF rx module for my Fatshark V3 Dominator goggles. You are right. I just hooked up my earphones in the earphone jack on my fatshark goggles and I was able to get audio from the...
  2. Connecting audio on the RMRC Cricket Pro - 5.8GHz VTX on a Redrotor RROSD PDB

    I just recently purchased a RMRC Cricket Pro - 5.8GHz VTX. I never found the need to fly my quad without the use of the built-in mic feature that comes with the Cricket Pro. I really want to start...
  3. FPV Freestyle on my Lumenier QAV-R (5"). This is...

    FPV Freestyle on my Lumenier QAV-R (5"). This is one awesome quad! Enjoy!

    Here is my set-up:

    Lumenier QAV-R (5")
    Lumenier Lux Flight Controller with Betaflight 2.5
    (Airmode enabled)
    GoPro...
  4. Here's an update on this thread. I had a chance...

    Here's an update on this thread. I had a chance to go through 10 4S 1300 mah flight batteries with a 60c rating after changing out my Lumenier 4Power Mini PDB for the Red Rotor RROSD Pro. My FPV...
  5. I might give those 5x4x3 Triblades a try. I...

    I might give those 5x4x3 Triblades a try. I really like to stick with the Triblades. Thanks!
  6. I am racing a Lumenier QAV 220 R and an Impulse...

    I am racing a Lumenier QAV 220 R and an Impulse RC 5 inch Alien race quad with the same FPV set-up with similar PDB boards. Both have a tendency of blacking out the fpv video when I push the quad to...
  7. I had a chance to change out my Lumenier 4Power...

    I had a chance to change out my Lumenier 4Power Mini PDB to the Redrotor all-in-one PDB with a regulated 12v video output pins to fpv camera and to VTx. I only had a chance to have 2 trial flights...
  8. FPV video cuts off when gunning the throttle on 4S lipo batteries

    Recently, I have issues where the fpv video cuts off during flight when gunning the throttle on 4S using lipo batteries rated at 60C and higher. WOT no longer than 5 second burst. My Vtx is soldered...
  9. Replies
    5,237
    Views
    1,544,232

    Sticky: Here's a little FPV freestyle Island Style with...

    Here's a little FPV freestyle Island Style with my Lumenier QAV 250 and Impulse RC Alien 5 inch triblades. Enjoy the video!



    https://www.youtube.com/watch?v=_006K4e3BkM
  10. The US Government has somehow been able to bury...

    The US Government has somehow been able to bury its nose once again and managed to impose federal regulations and over reaching its authority to the average US citizen on a freaking hobby that I love...
  11. Tim, Thank you for taking out the time for...

    Tim,

    Thank you for taking out the time for addressing my concerns about the Mudskipper 250 particularly concerning the choice of flight controllers. During the process of purchasing the...
  12. As you can see the difficulty mounting a CC3D FC...

    As you can see the difficulty mounting a CC3D FC which is considered as one of the industry standard FC's for a quad racer. The output ports for the ESC's extension actually touch the bottom of the...
  13. Mudskipper 250 Frame provides no vertical clearance for FC

    I just recently purchased the Mudskipper 250 frame during the recent Black Friday sale. This is a very beautiful frame. I was very excited to start the build of this frame; however, I notice 2...
  14. ReadyMadeRC Blue Series - RMRC2208 2300KV in FPV racing

    I have been using the RMRC 2208 2300KV motors with Lumenier 20 amp ESC's on 2200 Mah 3s set-up with HQ Bull nose props 6x4.5. These motors with this set-up are insanely fast. I get about 5 minute...
  15. Sleaper, I should be able to range test this...

    Sleaper, I should be able to range test this coming weekend. Iím just waiting for my IMRC 700 mw VTx to come in the mail. I have a 2.4 GHz VAS Pepperbox set-up on my all in-one-tripod which should...
  16. Thanks! I just used a GoPro quick release clamp....

    Thanks! I just used a GoPro quick release clamp. The other end just has double sided tape to mount to the back of my dvr. Grifiti Nootle also comes out with other stylish quick release clamps which...
  17. Replies
    4
    Views
    832

    Yes it can be done. I have a Flysight 5.8 GHz...

    Yes it can be done. I have a Flysight 5.8 GHz Black Pearl LCD. I can fly 5.8 GHz when you place the LCD in diversity mode. You can easily switch to AV In mode and acts as a stand alone LCD disabling...
  18. I was finally able to make a switch over from 5.8...

    I was finally able to make a switch over from 5.8 GHz to 2.4 GHz for LRS. I was able to get my 2.4 GHz VAS Pepperbox hooked up to my IMRC vRx Uno - filtered unit and plugged the vRx into the Video...
  19. When it comes to quality for a locked in video...

    When it comes to quality for a locked in video link, your antennas are consider a household name in the quad racing community! ;)
  20. I'm glad that Alex made the recommendation to...

    I'm glad that Alex made the recommendation to switch over to 2.4 GHz for long range as well as many other members of this forum including yourself instead of continuing with 5.8 GHz. 2km is not bad...
  21. Replies
    4,871
    Views
    1,002,048

    TBS might want to chime in but I can give one...

    TBS might want to chime in but I can give one more stab at this. Looks like your Xfire Rx is in find mode, try to press bind button on your Xfire receiver when your receiver is powered down to turn...
  22. Replies
    4,871
    Views
    1,002,048

    Looks like you have your transmitter to close to...

    Looks like you have your transmitter to close to your Crossfire receiver. The Crossfire transmitter is powerful and placing it to close to the receiver can damage your unit or cause your Xfire to go...
  23. Replies
    4,871
    Views
    1,002,048

    I have the exact set-up as yours provided that...

    I have the exact set-up as yours provided that your TBS Crossfire and your Naza M V2 are directly hooked up with servo extensions.
    Here is my servo extension hook-ups to the Crossfire:

    Channel 1...
  24. Guam Drone FPV Racers held it's first unofficial drone race

    Hello to my fellow FPV enthusiast,

    The Guam Drone FPV Racers (GDFR) held its first unofficial quad race with a decent turnout yesterday October 10, 2015. Our members had a chance to race the...
  25. Replies
    1,645
    Views
    322,349

    Going with the Crossfire and the 2.4 GHz TBS...

    Going with the Crossfire and the 2.4 GHz TBS Ground Station with either a Yagi or Pepperbox antenna sounds like a winning combination for the best range. I am pretty sure I have my mind set on the...
Results 1 to 25 of 66
Page 1 of 3 1 2 3