image

Search:

Type: Posts; User: Tronski; Keyword(s):

Page 1 of 12 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    158
    Views
    28,474

    for forums knowledge sake I will add this...

    for forums knowledge sake I will add this here...I have ran my DTF UHF 1W Jr module about 10-15 seconds without an antenna by accident. There have been other accidents in the past of a few seconds at...
  2. Replies
    4,245
    Views
    925,809

    Stealing wax string from work lol.

    Stealing wax string from work lol.
  3. Replies
    22
    Views
    1,469

    All I have heard is underwater with a hacksaw...

    All I have heard is underwater with a hacksaw blade in your hand. The dust is not good to breath in. I would imagine if you went slow it would be a clean cut. I did some arrow shafts and did not take...
  4. close this saga out finally after years, much...

    close this saga out finally after years, much research, and help from Shikra...its these damn microminims. I smoked my last micro when putting it into another plane and bought a new micro. This one...
  5. nice work thank you!

    nice work thank you!
  6. Thread: Mini Drak

    by Tronski
    Replies
    1,608
    Views
    190,834

    yeah what a mess...helination has it weighing...

    yeah what a mess...helination has it weighing 100gm and getFPV says 109gm. Neither of those are correct since these new motors are supposed to be heavier than a 2814/1700 so they can achieve the...
  7. Replies
    2
    Views
    1,334

    did you get anywhere with this? i made two and...

    did you get anywhere with this? i made two and they both were terrible lol
  8. Runcam split is semi soft mounted and the prop...

    Runcam split is semi soft mounted and the prop has been balanced now. The jello is gone finnaly. This plane has no toe in on the winglets. Between that and using thin ABS on them the tuning has been...
  9. Replies
    10
    Views
    5,196

    Keep in mind that calculator is talking about...

    Keep in mind that calculator is talking about absolute limits. You can do 4 miles with 2.4 video on rubber duckies, but you'll be flying in a snowstorm and lose video when you bank to turn home. ...
  10. Replies
    12
    Views
    1,572

    about 7 flights now and I really like them. the...

    about 7 flights now and I really like them. the resolution is noticeable in flight. I have a M9 gimble coming to hopefully get the most out of them. the arms they come with are kinda junky though. I...
  11. Thanks. So far so good. My biggest challenge is...

    Thanks. So far so good. My biggest challenge is jello with the runcam split. I've got to break out the prop balancer again :(
  12. Thanks! the original winglet and wing fence plan...

    Thanks! the original winglet and wing fence plan was based of your anubis. Wing fences were the original plan, but its done better then expected without them. These are the smallest winglets I've...
  13. Replies
    15
    Views
    1,868

    Probably just take your best sellers and make...

    Probably just take your best sellers and make them PNP and figure in the drak/MD probably get a few sales right now due to not needing lam.
  14. Replies
    2
    Views
    506

    do you have any tests for these 5200 cells? The...

    do you have any tests for these 5200 cells? The 4S one sounds interesting, but I would hate to buy it and find out the C rating is exaggerated.
  15. about 10-15 mph winds in that first vid. I...

    about 10-15 mph winds in that first vid. I usually don't even bother flying like that but I needed to try it out. The winds here on the coast are often very steady too compared to the choppy gusts...
  16. finally got her up today. Hard to tell much in...

    finally got her up today. Hard to tell much in all the wind but it looks like its going to be a great flyer.

    https://www.youtube.com/watch?v=VdO-V0ZoU-8&t=4s
  17. that flys nice! fortunately those wings are cheap...

    that flys nice! fortunately those wings are cheap and plentiful over here. I bet you saved a ton on shipping one overseas though.
  18. I hope so. I spent a lot of time trying to figure...

    I hope so. I spent a lot of time trying to figure out how to run parallel and single 4000 in the same plane and that was part of the solution. I gotta say though...the plane is as heavy as a brick...
  19. And a few steps left but CG looks promising. I...

    And a few steps left but CG looks promising. I think I hit my mark and I will be able to run either single 4S 3300/ 3S 4000 or dual 3S 4000 thanks to the oversized battery bay. Maiden this weekend...
  20. https://www.thingiverse.com/thing:2502827

    https://www.thingiverse.com/thing:2502827
  21. files needed. This shits open source so you guys...

    files needed. This shits open source so you guys can make it better :)
  22. Replies
    609
    Views
    66,133

    studying the amazingly effective sparring on the...

    studying the amazingly effective sparring on the 44 I found there is some newer and older revs out there. This is the newer style as far I can figure because it came with the newer motor mount(allows...
  23. Replies
    12
    Views
    1,572

    I am the proud owner of two TGY-390's now. They...

    I am the proud owner of two TGY-390's now. They are impressive just messing around with them. The resolution seems infinite and the holding power of neutral is way more than I expected. Both of those...
  24. It's the modern ritewing sparing. It really works...

    It's the modern ritewing sparing. It really works great. They are small enough to not require a channel so a razor cut will work.
  25. this is the super fancy bow I came up with. It...

    this is the super fancy bow I came up with. It worked well but the large size made fine control hard. if you have heavy small items to weight your foam down then you can make the bow smaller in...
Results 1 to 25 of 296
Page 1 of 12 1 2 3 4