image

Search:

Type: Posts; User: Sandor; Keyword(s):

Search: Search took 0.03 seconds.

  1. Tell me what is the procedure for connecting from...

    Tell me what is the procedure for connecting from the edge of the camera + GND VIDEO right or wrong?...
  2. Replies
    0
    Views
    295

    Reset 8 Channel Diversity Receiver

    I have EZUHF 8 channel Diversity Receiver firmware 1.53 I connect through YUSB ImmersionRC Tails v1.50 detected as ImmersionRC USB to UART (COM7) everything works well.. After disconnecting, press...
  3. Thread: EZUHF 2w

    by Sandor
    Replies
    200
    Views
    37,255

    I'm looking for immersionrc Irc ezuhf 433MHz...

    I'm looking for immersionrc Irc ezuhf 433MHz 33dBm 2 watts.Maybe they don't let them out anymore?
  4. Thread: EZUHF 2w

    by Sandor
    Replies
    200
    Views
    37,255

    Friends tell me where I can write the original...

    Friends tell me where I can write the original transmitter 2 Wat. I was confused by the device for$ 30 and paint which peels off
  5. I have a problem also ,new this thread people...

    I have a problem also ,new this thread people wrote that it was good toggles http://www.smartfpv.com/store/video-switches/5-rc-video-switch.html
  6. Works very well

    Works very well
  7. Tell me , what resistor (resistance) you put and...

    Tell me , what resistor (resistance) you put and where ?
    I also think that the camera has a very strong signal. https://youtu.be/NNP9J94Adgs

    https://youtu.be/NNP9J94Adgs
  8. Replies
    0
    Views
    402

    EzOSD and futaba 14SG

    Hello ,I bought an Immersion RCEzOSD and I want to get information about the signal strength of the control equipment Futaba14SG and R7008SB receiver .Please tell me what should I buy to track on the...
  9. On one copter transmitter is powered by a 4S...

    On one copter transmitter is powered by a 4S battery, and the camera from the 12 volt Converter.
    aguillamot what to include from one LNB ?
    I have to move the camera to another kopter therefore have...
  10. Tell me what could be the reason .Connect camera...

    Tell me what could be the reason .Connect camera Sony 960H CCD Effio-V 800TVL and the monitor go static . Tried different transmitters ,the result is the same ,but if you put a different camera ,no...
Results 1 to 10 of 11