image

Search:

Type: Posts; User: rotary65; Keyword(s):

Page 1 of 19 1 2 3 4

Search: Search took 0.04 seconds.

  1. So it's a SOT23-6 packed voltage regulator, ...

    So it's a SOT23-6 packed voltage regulator, 7-20v input, probably buck type, probably 5v output, relatively low current. Would be nice to know the actual specs and replace it with a better...
  2. The concerns over the price tag are a bit odd to...

    The concerns over the price tag are a bit odd to me. Frsky represents value, not greed. Look at the specs and you know it will be worth every cent. It has more goodies than anything in that range...
  3. Fx796T fried. Help me ID component please

    I have a new FX796T vtx that died after its 3rd flight. The 6 pin IC in the lower middle of the board is blown, but I can't fully read the part number as a part of the IC is gone. Can anyone...
  4. Attitude v2 vs. Dominator v2 ... which do you like better and why?

    I had the Dom HDs and kept my Dom v2s. I bought the HDs for 3D, tried it and didn't like it, so sold my HDs. I did really like the HDs, but the V2s are a better value for me once the 3D was out of...
  5. Replies
    21
    Views
    13,690

    Oh my gosh, those Headplay goggles are huge!

    Oh my gosh, those Headplay goggles are huge!
  6. Replies
    21
    Views
    13,690

    If you want to fly 3D, the HDs will do it while...

    If you want to fly 3D, the HDs will do it while the V2s won't. Otherwise, it's as PeteDee says.
  7. Mending a broken off SMA (Antenna) plug from an Immersion RC or FatShark Tran...

    I don't understand what the design of this product has to do with where you mount it and the fact that you're constantly crashing. An SMA connector soldered to the PCB is how everyone does it.
    ...
  8. Why do my quads suddenly pull back hard when flying forward in rate mode?

    Sounds like I term to me too Alex, but might be P too. Try the procedure from KK on the TBS:


    "Roll/pitch P-tuning:
    Set the gains and limits to the following values:

    Roll/Pitch P-gain: 30...
  9. Replies
    6
    Views
    32,714

    Can I use a GPS with my Open Pilot CC3D

    The CC3D is fine for 250 racers and lots of people use them. The newest firmware (14.10) was focused on making 250s fly better.

    Since you already have a CC3D, use it as is - there is no need to...
  10. ...and they're gone!

    ...and they're gone!
  11. Exactly - the headtracker is standard on all HDs.

    Exactly - the headtracker is standard on all HDs.
  12. I am stunned that these are still there! Surely...

    I am stunned that these are still there! Surely not for much longer!
  13. Replies
    296
    Views
    43,553

    Fatsharks new product update thread..... HD's?

    Heads up! There are 2 HDs in stock right now at one supplier:

    http://www.nghobbies.com/cart/index.php?main_page=product_info&cPath=1_170_171&products_id=1054#.VIcV95b3bCQ

    Edit: and they're gone!
  14. Replies
    144
    Views
    40,250

    Initial impressions: I received my HDs...

    Initial impressions:

    I received my HDs yesterday and got to compare them with the v2s and with the Nerdcam. This was all indoors as the weather here will be poor until Spring with few flight...
  15. Replies
    6,324
    Views
    941,676

    New Fat Shark Products for 2014

    @omegooliebird; Nothing cold made of glass that you put 1-2 from your warm face outdoors in the cold is going to avoid fogging unless it blows air across the surface at speed (and dries your eyes...
  16. Replies
    6,324
    Views
    941,676

    It's possibly more for the minis and trees at...

    It's possibly more for the minis and trees at closer ranges and group racing frequency combinations. The 1.3 surely is a much smaller target group, so it must be difficult to give it any priority....
  17. Replies
    6,324
    Views
    941,676

    I received my HDs today and am happy to say that...

    I received my HDs today and am happy to say that they work well for me. These HDs have the newer panel covers that are easily removed, but are secure when installed; no need to loosen screws on mine....
  18. They're just producing a lot of stuff. I can only...

    They're just producing a lot of stuff. I can only imagine that they're very hard at work filling orders for all sorts of products in time for Christmas for some large retailers and many others.
  19. October 30th, RMRC shipped 30 HDs.

    October 30th, RMRC shipped 30 HDs.
  20. Replies
    93
    Views
    22,219

    No problem; I understand that the price puts it...

    No problem; I understand that the price puts it out of the reach of some, but it is actually a good value considering. Think of it as closer to a custom one-off in terms of R&D and quantities.
    ...
  21. Replies
    6,324
    Views
    941,676

    They're still going out. My HDs shipped yesterday...

    They're still going out. My HDs shipped yesterday from New Generation Hobbies in Canada. I originally ordered my HDs in March.

    RMRC and GetFPV both have shipped out significant quantities of HDs...
  22. Replies
    93
    Views
    22,219

    On the Chinese angle, this is a very carefully...

    On the Chinese angle, this is a very carefully designed specialty camera that is produced in very small quantities. The extensive engineering effort put into this camera so that it could be certified...
  23. Anybody Receiving Fatshark Dominator HDs from ReadyMadeRC Yet?

    Sigh. Ordered HDs from RMRC on March 5th to get in a triple digit line, but jumped ship in June to get in a single digit Canadian line at NGHobbies, but RMRC has gotten 85 sets in October while NG...
  24. Replies
    6,324
    Views
    941,676

    New Fat Shark Products for 2014

    He was asking about the v2s. I was talking about the carrying case colour.
  25. Replies
    6,324
    Views
    941,676

    53337 But you can't see that without opening...

    53337

    But you can't see that without opening the box...
Results 1 to 25 of 456
Page 1 of 19 1 2 3 4