PDA

View Full Version : How to flash Vortex 250 with Betafligh



sdloo
16th February 2016, 08:57 AM
Hi folks

how can i flash the Pro with betaflight_IRCFUSIONF3_v2.3.3a.hex? Must i use cleanflight with local firmware, what must be setup? No reboot sequence, Full chip erase ??? Any help i welcome :) or what should i do for the airmode?

yann
17th February 2016, 01:41 AM
Hi,

Make sure Vortex has finished init sequence ( all led board blinked in green ) before connecting to USB.

To flash vortex 250 flight controller, you must use cleanflight-configurator (https://chrome.google.com/webstore/detail/cleanflight-configurator/enacoimjcgeinfnnnpajinjgmkahmfgb) with local firmware ( you are right indeed ).
Enable "Full Chip Erase" only.

Once you have flashed FC, rerun the OSD txWizard ( I assume you already updated it to 1.0.0.24 ).

To enable Airmode you would need to setup a mode via cleanflight-configurator (https://chrome.google.com/webstore/detail/cleanflight-configurator/enacoimjcgeinfnnnpajinjgmkahmfgb) Modes tab.

Hope this helps.

sdloo
17th February 2016, 02:09 AM
thx. a simple trick will work. if you can not flash the fc, just select naze in cleanflight and go on with local flashing. it works.

70495

yann
17th February 2016, 03:16 AM
Thanks for sharing!

This sounds like a bug in cleanflight-configurator !?


thx. a simple trick will work. if you can not flash the fc, just select naze in cleanflight and go on with local flashing. it works.

70495