PDA

View Full Version : Nerdcam 3D OSD support



QuickSavage
23rd January 2016, 04:46 PM
Hi all,

I'm doing an experiment where I'll be putting a Nerdcam 3D onto the Vortex 250 Pro, but I'm fairly sure the OSD will be unreadable in 3D mode, since half will be on the left eye and half on the right eye once my Dominator HDs are in 3D mode.

Does anyone have any advice on how to configure the OSD so it's usable in 3D mode?

Does anyone know if side-by-side 3D OSD support is planned for the Vortex?

Thanks,
John

ksmith624
23rd January 2016, 04:51 PM
Is the 3D FPV better than typical 2D?

QuickSavage
23rd January 2016, 05:55 PM
I plan on finding out :). For high-level flying apparently it isn't much use, but when flying a few metres from the ground, I'm expecting for it to be a help with judging height and distance to e.g. turning points... or trees ;).

I'll be adding a pan/tilt/roll rig aswell, but I have a feeling that will actually end up making it more difficult to fly. One step at a time though!

Any thoughts on a 3D-capable OSD?