PDA

View Full Version : Tilted / Angled Motor Mounts



chatch
27th December 2014, 04:58 PM
http://www.realfpv.com/TiltMounts.aspx

http://i.imgur.com/SZV5Fl6.png

JG-rn
31st December 2014, 12:31 PM
Chatch,

These will fit on BO arms nicely?

chatch
31st December 2014, 01:33 PM
I don't think so, what angle are the arms on BO at?

JG-rn
31st December 2014, 01:35 PM
What do you mean what angle? They are level.

chatch
31st December 2014, 01:38 PM
If you look at the quad from the top, measure the angle between the X axis and the arm. If you put the Spanky mounts on a BO frame the motors will be tilted, just not pointing forward

JG-rn
31st December 2014, 01:42 PM
Oh, I see what your saying. I'm not sure what the angle is, I'll see if I can measure it.

chatch
2nd January 2015, 04:11 AM
any luck?

Dust
4th January 2015, 12:03 AM
For what its worth, I got some very much like this a few days ago. I got mine from http://store.ivc.no/ and they are marketed for QAV250. I can say after many attempts to get the pieces in the right way, that they do fit a Blackout quad no problem. 10 degree only, but if that helps Chatch or JG, then there ya go. It took me a while to notice that there are 2 wedges' hole pattern in an X and 2 wedges's hole pattern in a +
I would be interested in trying out both 15 and 20 degrees as well, so if we can find out if your does fit, or if you can make some that fit, You got a customer from me anyway.

quiXilver
22nd March 2015, 09:04 PM
Sorry to raise this thread from the dead, but I just got some of these for my quad and I reconfigured my flight controller so it hovers fine, but now it doesn't seem to go as fast because it won't tilt as far forward as it used to. How do I compensate for this? I have a Naze 32 w/baseflight. Flying in ANGLE mode.