PDA

View Full Version : Pilot HD stopped working because of broken component



Patouf
26th May 2014, 01:43 PM
Hi, until yesterday I was using my camera without any issues, but when I plugged it, the led was dull and I had no video out (only black screen). I searched on the forum for similar cases and when I opened it I found that a component had literally burned out (the one with 3 legs visible on the top corner). I noticed someone else had the same issue (same component broken :http://fpvlab.com/forums/showthread.php?27308-fatshark-pilot-hd-camera-not-working)
I was running the camera of my Vtx.
Is this covered by warranty? (the kit is less than 6 months old)
46763

hpcoolahan
27th May 2014, 04:24 AM
Start up a ticket at support@fatshark.com .
What batt voltage where you running off btw ?


Cheers
Patrick

Patouf
27th May 2014, 10:38 AM
Ok thanks.
I was running of a 3S on the balance plug.