PDA

View Full Version : fatshark 5.8ghz 100mw 12V to camera.



metro23
14th February 2014, 12:27 PM
Hi, I bought this VTx (Picture).
I use a KX-171 12V camera.
Does the VTx like a 3S Lipo ?
On the lable it Shows 6-12V.
But I found a Manual with says 6-9V direct only.


If I use a 2S Lipo for it, I Need to stepup the 5V Output to 12V.
I have These one:
http://www.globe-flight.de/StepUP-Wandler-fuer-12V-Kameras


I want to solder it between the Molex 5Pin and the Camera.


But Globeflight means that it would not work with fatshark TX, but why ?


Regards

FatShark
14th February 2014, 10:40 PM
That TX is ok for 3S (not 4S). The 5V - 12V step up can be soldered inline between the 5V out of the TX camera 5p Molex and 12V camera.