HK Tiny OSD Firmware problem

[boopidoo]

I've the HK Tiny OSD and while I know it's a re-branded Skylark Tiny II OSD I hope someone could shed some light to what is happening. I've ordered an USB-cable from ReadymadeRC and I've also downloaded "Configure Tools V3" and the "Tiny II V2.7.bin" firmware.

When trying to update the firmware it says "Erasing..." and then "Erase timeout"? The OSD now states that it is V2.7 so somehow I managed to update the firmware or does the Erase timeout appear because the firmware is already uploaded?

Also when trying to update/change any settings nothing in the OSD really changes, it's like it's not really connected somehow? In the software the default seem to be "Standard" screen with radar etc however the screen shown on the OSD is the simple screen.

Any suggestions?

[MASHTON1138]

Put up a screen shot please so I can see what the program is doing.

[boopidoo]

Sure here's two screenshots. The first one shows the software after I've tried to select standard screen and to show RSSI in percent. The other shows the FW error.

[boopidoo]

Well, problem solved. It was something I actually knew about but somehow didn't check. The problem was the COM port which was set to 38, when I lowered it to 2 everything seems to work.

[MASHTON1138]

Ok glad you got it worked out.