Results 1 to 2 of 2

Thread: Vendetta cube to xfire v2 wiring help

  1. #1

    Vendetta cube to xfire v2 wiring help

    Trying to install crossfire into my vendetta cube. I attached the BST to the core, but I have no idea where the channels go on the power cube. Or how to connect them. Tried looking at the crossfire manual page 35 and I'm confused. Is there a video of installing this somewhere I can't find one on utube. I'm trying to post a picture of what I have to help. But upload isn't loading for some reason.

  2. #2
    Navigator cracymarc's Avatar
    Join Date
    Jul 2014
    Location
    Germany
    Posts
    159
    might a bit late, but you can connect the ch1 from the rx straight to the rx port in the colibri fc.

    or- whats even better- conect pin 1/ 2 to uart 1 or 3, set your pinout of the rx to crsf and also the betaflight protocol.

    https://kamikatze-fpv.de/tbs-crossfi...flight-english


    Gesendet von meinem ASUS_Z00AD mit Tapatalk

Similar Threads

  1. ET Vector > XFire full telemetry ETA.?
    By rangler in forum TBS Support
    Replies: 3
    Last Post: 14th September 2016, 04:03 PM
  2. perna? TBS xfire,core pro with aftermarket gps?
    By doobie in forum TBS Support
    Replies: 2
    Last Post: 12th September 2016, 10:41 PM
  3. Vector <> TBS Xfire Serial Telemetry
    By rangler in forum Eagle Tree Systems
    Replies: 5
    Last Post: 11th September 2016, 12:03 PM
  4. xfire diversity question
    By doobie in forum TBS Support
    Replies: 0
    Last Post: 31st May 2016, 06:46 AM
  5. Replies: 3
    Last Post: 9th March 2016, 07:51 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •