Results 1 to 2 of 2

Thread: TBS unify pro hv - lc filter question

  1. #1

    TBS unify pro hv - lc filter question

    I'm working on a new build and first time with the unify pro hv and looking forward to using it.

    I will be connecting it directly to the lipo along with a 4 in 1 esc and fc, I've been reading advice and the general consensus is to use an lc filter although the product page doesn't mention having to do this.

    If rather not have to use an lc filter as it's a tight build but will make room if it is advised. If so is there any particular filter I should get?

    Thanks for any help.

  2. #2
    Well I'll try connecting the unify hv direct to the lipo / esc power pads without a filter to start with and see how it goes.

Similar Threads

  1. Fatshark Power Filter question
    By chad2323 in forum Fat Shark R/C Vision Systems
    Replies: 2
    Last Post: 19th July 2014, 05:23 PM
  2. EzOSD Wiring Question LC Filter?
    By utz in forum ImmersionRC
    Replies: 0
    Last Post: 12th January 2013, 07:38 PM
  3. question about saw filter install on vrx
    By redline870 in forum Team-Black Sheep
    Replies: 3
    Last Post: 4th January 2013, 01:03 AM
  4. LC Filter Question
    By detonator in forum Team-Black Sheep
    Replies: 1
    Last Post: 11th November 2012, 07:44 AM
  5. 433 LP filter - EZUHF question
    By Ken Crawford in forum ReadyMadeRC
    Replies: 5
    Last Post: 14th January 2012, 08:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts