Results 1 to 2 of 2

Thread: 7" vendetta arms and TBS endurance motor issues

  1. #1

    7" vendetta arms and TBS endurance motor issues

    Hi guys,

    So just started playing with the 7" arms and TBS endurance motors running HQ 7045 DD Props and there is a sporadic twitch that comes through the motors.

    I'm running Magnus's betaflight 3.0.1 tune and esc's are flashed with Bl_Heli 14.9

    I am currently going through a process of elimination and so far have:

    - increased and decreased pids to try tuning it out
    - replaces a dodgy sounding motor
    - reduced motor timing from MED/HIGH > MED > MED/LOW

    Next ill be trying

    - a different set of props
    - test motor timing HIGH and LOW
    - Flashing Cleanflight

    I am really looking some more info on what could cause this and if anyone else has had this issue before...

    Cheers

  2. #2
    There seems to be nothing out there regarding this setup for the Vendetta. I am in the same boat and searching.

Similar Threads

  1. 7 Inch Vendetta Arms- what PIDS
    By MrBob6939 in forum Team-Black Sheep
    Replies: 3
    Last Post: 14th November 2016, 03:10 PM
  2. Vendetta 7 inch arms availability
    By MrBob6939 in forum Team-Black Sheep
    Replies: 0
    Last Post: 17th October 2016, 12:32 PM
  3. Endurance arms landing gear
    By Danr_657 in forum Team-Black Sheep
    Replies: 3
    Last Post: 13th September 2015, 06:15 AM
  4. Angled Motor Mounts For "Flat" Arms?
    By 500Driver in forum ROTORCRAFT
    Replies: 31
    Last Post: 11th November 2014, 11:29 PM
  5. TBS Discovery Endurance - with RCT-800 arms..
    By iheli22 in forum Team-Black Sheep
    Replies: 3
    Last Post: 25th September 2014, 09:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •