IMMERSIONRC EZUHF RX RSSI and EZ Antenna Tracker Telemetry Data ISSUE?

[zozolione]

I've made yesterday following vid. shows a confusing Alarm which is displayed:

"When I move the elevon and aileron I get a Alarm and the RSSI Signal move significant, what could be wrong?

Also the displayed RSSI Value is Confusing me, the Values move up and not down when the Signal decreases?


View this video on YouTube

Also I do not receive any Telemetry Data to the EZ Antenna Tracker?

-I've checked the wiring and looks good also reloaded the Firmware 1.10V and
can not read any data from antenna tracker at the Immersion RC Tool Software also the the device is not shown as USB-Device but I can update the firmware when I start it with the middle button pushed?

At the antanna tracker I get good Audio Level Signal but no:

No Decoder Data?

How can I reset the EZ Antenna Tracker?



This is what I get when I connect my IPhone at the AV Out from the Power Pox which is connected to the IMRC Receiver 2400, the GPS Telemetry is working but without the RSSI Values?:


Thank you for your support!

[aeryck]

I had an issue on my old ez* where moving the ailerons would cause the rssi values to drop way down and the servos would be very jumpy with their movements.. it turned out that the servos were causing extreme power drains on my system and the receiver was browning out. I had to replace the servos to fix the problem.

Dont know if its the same issue you are having, but maybe check and make sure the servos arent binding or stalling on anything? Have any other types of servos you can plug into the rx and see if it changes? The servos i had to replace were corona ds939mg digital servos.

[zozolione]

Hi aeryck

Hm..I've a 7.5 Amp UBEC on board but I'll check it with other servos.

Ok, this can't be the reason cause the current still at 0.3 / 0.4 Amp at the osd in the 1. Vid post.

[Blizzard1287]

hey zozolione, I had this problem with my Zeph a while back, what kind of servos are you using?

[zozolione]

Using hitec hs645 mg

[Blizzard1287]

ok, those are good servos. On your cable connecting the Rx to the OSD make sure there is no ground wire being used. It'll cause a ground loop.

[zozolione]

Ok, I'll check it!

[zozolione]

I've wired the RX to the EZOSD like on this pic:

[zozolione]

Oh man, also recognized that I hed 31 Failsaves in the first vid post at RSSI Value? I just don't know where to start to locate the issue?

[zozolione]

This is my ten times proved wiring schematic:
ISSUE RSSI.pdf

1. ISSUE: After connecting the RSSI plug to the RX all values disappear on EZOSD Screen?

http://www.youtube.com/watch?v=KyYPuuvhmDs


2. ISSUE: The Antenna Tracker doesn't receiving any GPS Data?

http://www.youtube.com/watch?v=pkNjumO-s2k


Thanks