the screen boots up when you hold the scan button- thats right (viewer mode - mudul bay is ddeactivatet)
after plugin in the usb cabel the screen shloud turn off. otherwise - my solution for a lot of problems: try a factory reset
for the telemetry: everything is configured right in betaflight? telmetry on, sport on, speed auto?
Telemetry is still not showing voltage in the interface. I'll keep working on it. I'm in Betaflight, FrSky telemetry is active on UART2, Telemetry mode is enabled, etc.
Yes, I get the voltage warning onscreen "DRONE LOW BATT".
sounds mor like from a osd? normaly the tango should start to beep
When I use my QAV-R with a Betaflight F3 board and FrSky X4R-SB Rx, I get the voltage readout in the Tango menu. So I know it's working. I'll see why the Moskito isn't kicking out telemetry now.
here a a few common problems when the telemetry won´t:
- telemetry inversion needs to be on/off
- telemetry speed isst not set to auto
- aktivated telemetry under "general" ?
I'm getting RSSI in the Tango - not sure if that's from telemetry or not, but voltage is not showing up.