M'ck'y 50" EPP fpv wing 2 x 3s3300mah

[M'ck'y]

The perfect size for carrying around in most n

ormal cars and practical enough for road trips and holidays.

It is home-cut high density EPP and will be powered by 2 x 3s3300 for quicker charges as opposed to 4s power systems.

Build is pretty much straight forward as I have done this before.

I can't wait to see the numbers that comes out of this baby. Flying weight target is about 1.8kg and a flight time of at least than half an hour.

Complete Eagletree all round with guardian stabiliser and rth of course should allow stress free flying and shooting of the holiday sites

The build is actually completed and the plane has had its maiden already. Flight was amazing, once cg was adjusted. I had to add weight to the nose.

Updates:
Equipment
Batteries 2 x 3cells 3300mah in parallel
Motor 3536 1400kv
Folding 10 x 6 Prop much easier to launch with over 1:1 thrust
60amp ESC with Brake On

Static Tests
10 x 7 @ WOT = 58 amps & 1750g thrust
10 x 6 not static tested

Performance with 10 x 6 folding prop

Weight 1.8KG
Cruise Speed ~60km/hr @ 12 amps
Stall 35 km/hr
Powered Top speed 110km/hr WOT @ 44amps (level flight) or 146Watts/Pound
Endurance ~30 mins
Range ~30kms at cruise

I will be doing further tests this week with videos to show off these numbers. Stay tuned.

Photos coming up next

[M'ck'y]

Bays and equipment in...

This motor is not powerful enough, so still experimenting with different ones atm.


Just needs to be laminated now...

[M'ck'y]

fiberglassed and laminated


Another look inside the bays.

[egosession]

What size of spars do you use there?

And could you right down all the specs? Like servos, motor, esc, fpv stuff etc

[M'ck'y]

This mount was a b* to make, and not worthwhile to make your own, Specially when TBS has them for $25 go get it from him

I just like building things and wanted to experiment a little there.

[M'ck'y]

parallel battery wires are in.
These are 2200 mah, which will be replaced by 3300, and obviously, bigger size battery bays. (made out of 3mm plywood)

[M'ck'y]

What size of spars do you use there?

And could you right down all the specs? Like servos, motor, esc, fpv stuff etc

I'll add the specs in first post

5mm outside 4 mm inside carbon tubes.
Hextronic medium size digital metal gear ball bearing servos
60a HK ESC
motor isn't right yet, and i'm still experimenting

FPV
690 wdr pixim built in osd control
TBS PSU
2.4G 500mw lawmate
EZUHF
Complete Eagletree
4 x fibreglass rods
5 mil laminate

[M'ck'y]

[aaron_gx]

Way too awesome. Great build. 1.8kg auw?

[M'ck'y]

yes will be 1.8kg with the 2 x 3s3300