I had my stuff working last night then I tried to figure out how to wire up the Skylark and I think I messed up my tx for the plane. I got power to the skylark. I powered it of a BEC. Then I could not figure out how to get the osd to show up on the video. It says video in then video out then a ground. However I tried all those in a variety of combos and could not get it to show up. Then After all my screwing around I can't get a a picture now even setup with original config.
Using a Skylark osd
Ready made RC tx on the plane.
Can anyone help me I am sure it is a wiring issue just not sure where