New Tricopter Delrin Kit

[timnilson]

Thanks Tim,
Just tried to order the gear from your site and I see that the props I want are also out of stock. Do you know how long before these come back? I may as well wait till everything is in stock before I place the total order.
As for flying, I am going to use a flight sim and connect that up to my DX6i and see how that goes.

In regards to the USB loader, I can't seem to find info. Probably not searching for the right terms. Can you recommend one?

The APC props you can get from lots of places, but the tricopter will take a while to get back in stock. I would recommend you order the tricopter right now (I just checked and there really is only one left in stock). It's been a bussy weekend already and I have no doubt the last tri kit will be gone in the next 12 hours.

USB Loader: HK now sell them (and has them in stock): http://www.hobbyking.com/hobbyking/s...occessors.html

[Ant]

Thanks again Tim,
I have placed the order through your site and will order the other gear through a few different places.
I guess I have now officially started my journey into the wonderful world of tricopters.

[timnilson]

Thanks again Tim,
I have placed the order through your site and will order the other gear through a few different places.
I guess I have now officially started my journey into the wonderful world of tricopters.

Great. Good luck to you. You will have ups and lows in this hobby, just be aware. I really do recommend you get a foamy to get the hang of flying -- they are hard to destroy.

[MoRaLeSD]

Hi!!! I am now ordering the battery for the Derlin Tricopter. This can be used right?

Turnigy nano-tech 6000mah 4S 25~50C Lipo Pack

It is too big and I should take a smaller one? I am planing on using them for FPV so I can get the Maximum flight!

or this one?

Turnigy nano-tech 5000mah 4S 35~70C Lipo Pack

[timnilson]

Hi!!! I am now ordering the battery for the Derlin Tricopter. This can be used right?

Turnigy nano-tech 6000mah 4S 25~50C Lipo Pack

It is too big and I should take a smaller one? I am planing on using them for FPV so I can get the Maximum flight!

or this one?

Turnigy nano-tech 5000mah 4S 35~70C Lipo Pack

Wow... that is big. I did not know they made a 6000mah 4s. Honestly, I think you may want to stick with the 5000mah as it is a lot lighter. It will provide you lots of flight time as well. And, you must have a power set up like the NX-4008 and 10x4.7 props.

[MoRaLeSD]

Wow... that is big. I did not know they made a 6000mah 4s. Honestly, I think you may want to stick with the 5000mah as it is a lot lighter. It will provide you lots of flight time as well. And, you must have a power set up like the NX-4008 and 10x4.7 props.

Yes yes! Thank you very much Tim!! I will take this one! Do you know if it is better to Keep the BECs from the ESCs or I should have an external one for insurance?

[timnilson]

Yes yes! Thank you very much Tim!! I will take this one! Do you know if it is better to Keep the BECs from the ESCs or I should have an external one for insurance?

You can use either a dedicated BEC or use the ESC.

[MoRaLeSD]

You can use either a dedicated BEC or use the ESC.

The ESCs have 3 BECs, all used? I mean if the one from the 3 don't work it uses the 2 others? Is it more safe to do it like this, or it's safer to remove all the 3 and use an external?
Just for insurance! Who wants to have a fool crash because a bad BEC?

[timnilson]

The ESCs have 3 BECs, all used? I mean if the one from the 3 don't work it uses the 2 others? Is it more safe to do it like this, or it's safer to remove all the 3 and use an external?
Just for insurance! Who wants to have a fool crash because a bad BEC?

I personally never had a plush ESC BEC fail on me. The KK board is ok with all three ESCs providing the 5v in parallel. So even if one ESC BEC fails, you have 2 more. However, some FC boards want clean power provided by a separate BEC (like the MultiWiiKK Board).

[MoRaLeSD]

I personally never had a plush ESC BEC fail on me. The KK board is ok with all three ESCs providing the 5v in parallel. So even if one ESC BEC fails, you have 2 more. However, some FC boards want clean power provided by a separate BEC (like the MultiWiiKK Board).

I understand! Thank you very much for your help Tim! I will go with the ESC then!