image
Tab Content
  • SaG˘'s Avatar
    15th August 2017, 03:50 PM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    Gotcha. Hehehe quite an adventure. Glad you landed safely back on earth
    1700 replies | 261291 view(s)
  • SaG˘'s Avatar
    14th August 2017, 05:01 PM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    Wait, you mounted the VHB tape underneath the bottom layer, not the black plastic mounting plate?
    1700 replies | 261291 view(s)
  • SaG˘'s Avatar
    13th August 2017, 11:18 AM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    yup, easy disassembly starting from top layer ;)
    1700 replies | 261291 view(s)
  • SaG˘'s Avatar
    11th August 2017, 06:04 PM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    or do this: no VHB tape under mounting plate. o-rings between frame and mounting plate. metal screws through frame into ground standoffs. nylon...
    1700 replies | 261291 view(s)
  • SaG˘'s Avatar
    10th August 2017, 09:24 AM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    By default, motors should stop spinning when you disarm. When you arm, they spin at idle (minimum throttle). What behavior are you expecting? Now if...
    1700 replies | 261291 view(s)
  • SaG˘'s Avatar
    19th July 2017, 08:31 PM
    SaG˘ replied to a thread TBS POWERCUBE in Team-Black Sheep
    i had the exact flight stack/esc setup and used a 35V 1000uf cap at the lipo solder joint. bird flew well. is it necessary? it definitely helps, but...
    1700 replies | 261291 view(s)
No More Results
About SaG˘

Basic Information

Statistics


Total Posts
Total Posts
125
Posts Per Day
0.27
Last Post
TBS POWERCUBE 15th August 2017 03:50 PM
General Information
Last Activity
17th August 2017 10:21 PM
Join Date
4th May 2016
Referrals
0