1. Announcement:
    FPVLAB ‎(Tha Bawss)
    24th February 2011
+ Post New Thread
Page 2 of 119 FirstFirst 1 2 3 4 12 52 102 ... LastLast
Threads 21 to 40 of 2364

Forum: RC TECH

(??s about your control, receivers, ESCs, batteries or tech help)

  1. Sticky Thread Sticky: Official Connector Thread

    Sentry could you please Sticky this? I've seen the question asked many a time, for connectors and where to get them, I figured why not start and...

    Started by injector‎, 7th October 2012 11:27 PM
    16 Pages
    1 2 3 ... 16
    • Replies: 151
    • Views: 26,567
    22nd October 2014 02:15 PM Go to last post
  2. Sticky Thread Sticky: 2.4ghz Control Megathread - Spektrum, Futaba, FrSky, etc

    Thanks to my brother I was able to do some extensive range testing with my DX8 radio. He lives on a smallish inland lake in MI, so while I had...

    Started by aeryck‎, 22nd August 2011 10:23 AM
    24 Pages
    1 2 3 ... 24
    • Replies: 230
    • Views: 32,607
    21st October 2014 09:20 AM Go to last post
  3. Sticky Thread Sticky: LETS TALK CHARGERS

    Time to upgrade to a decent multiple-charger (lipo) since my bigger models run 5000mAh or bigger. I'd like to be able to charge 1 - 4 lipos...

    Started by SENTRY‎, 24th September 2011 01:07 AM
    19 Pages
    1 2 3 ... 19
    • Replies: 181
    • Views: 14,514
    18th October 2014 05:00 PM Go to last post
  4. Sticky Thread Sticky: Lipo break-in: The how, why, and benefits of a DIY discharger

    I've been doing a lot of reading on lipos recently and one thing that stuck out was how a few people were breaking in their batteries. Up until now...

    Started by PnoT‎, 9th May 2011 01:48 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 17,745
    29th April 2014 05:34 PM Go to last post
  1. ZTW Spider Series 6S compatible ESC - anyone used these before?

    I'm looking for a 6S compatible multi-rotor ESC (20A max is fine), but the critical thing is it can't be any wider that 25mm. I've found the ones...

    Started by Ian Davidson‎, 7th August 2014 08:34 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 453
    17th October 2014 04:29 PM Go to last post
  2. Funky Turnigy, not sure if HW or SW?

    I just bought this a couple weeks ago, haven't used it successfully yet, it died (or ?) before I got a chance to fly anything with it. I think the...

    Started by HatTrick‎, 17th October 2014 03:17 PM
    • Replies: 0
    • Views: 56
    17th October 2014 03:17 PM Go to last post
  3. Mounting bracket

    Anyone know where you can buy just the Range Extender Mounting Bracket itself that goes with the DJI range extender? I've tried everywhere I can...

    Started by thudweasel‎, 17th October 2014 01:27 AM
    • Replies: 0
    • Views: 66
    17th October 2014 01:27 AM Go to last post
  4. Best placement of FrSky PCB-antennas

    Hello ladies and gents! I'm a little confused about how to align the FrSky PCB-antennas 'correctly' Most of the time, people in forums recommend...

    Started by bubuu‎, 15th October 2014 11:04 AM
    • Replies: 1
    • Views: 148
    15th October 2014 10:42 PM Go to last post
  5. Antenna Seperation

    I need to get some separation between my video and receiver antenna. I have a stock DJI F450 with a 400mW video transmitter and EzUHF receiver. Prior...

    Started by Jeff_b‎, 8th October 2014 04:01 PM
    • Replies: 6
    • Views: 245
    15th October 2014 11:50 AM Go to last post
  6. OrangeRX 3-axis stabilizer works well

    Started by squishy‎, 23rd October 2012 03:50 PM
    • Replies: 8
    • Views: 832
    15th October 2014 01:14 AM Go to last post
  7. Orange 3-Axis stabilizer v3 question

    Hello! Mounted my orange flight stabilizer on my wing yesterday, i after i while i got the controls correct and stabilizer working correct (i...

    Started by gabsterino‎, 15th October 2014 01:12 AM
    • Replies: 0
    • Views: 50
    15th October 2014 01:12 AM Go to last post
  8. Behavior of Turnigy receiver controlled switch

    I have a total of 3 receiver controlled switches. Hobbyking must have changed the hardware or firmware on them, because 2 of them operate...

    Started by SecretSpy711‎, 12th October 2014 06:55 PM
    • Replies: 7
    • Views: 196
    14th October 2014 11:07 PM Go to last post
  9. Diagnosing a dodgy Frsky receiver

    Hey guys, Had a V8R7-II on my skyfun jet which met the ground at a rapid rate of speed and repurposed itself as a tunnel boring machine. Now...

    Started by keltik‎, 13th October 2014 11:21 PM
    • Replies: 3
    • Views: 137
    14th October 2014 01:30 AM Go to last post
  10. Trouble Binding Taranis with X8R

    TBS just built and sent me a new discovery to replace my old one. So now I want to bind my Taranis transmitter with the X8R on the new quad. ...

    Started by Mill‎, 12th October 2014 08:59 PM
    • Replies: 6
    • Views: 168
    13th October 2014 11:39 PM Go to last post
  11. LRS UHF: Letís talk about antennas

    Except for Roberto Montiel, Trappy and some other crazy guys, the reality is that all the LRS UHF RC systems offer a reliable RC signal over...

    Started by sircana‎, 28th May 2012 06:13 PM
    26 Pages
    1 2 3 ... 26
    • Replies: 255
    • Views: 42,361
    13th October 2014 03:52 PM Go to last post
  12. battery wiring question (5s from two 3s lipo's)

    so i just had this idea cross my mind. i have 2 set of 5000mAh 3s lipo's and i was going to sell them but they have been sitting for a while now...

    Started by Need4Speed‎, 8th October 2014 08:12 PM
    • Replies: 3
    • Views: 148
    13th October 2014 01:00 PM Go to last post
  13. Ramping Up for FPV

    First off: Hello! I'm obviously new here, and not quite new to RC flight. Used to do some park flyer stuff years ago with my father. After not...

    Started by InaneCathode‎, 10th October 2014 12:50 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 417
    13th October 2014 08:11 AM Go to last post
  14. ezuhf failsafe settings with multiple rx's

    here's the question guys: i've set my ezuhf failsafe for my disco and am happy that it's working. however, i have other rx's that i want to use...

    Started by nowler‎, 12th October 2014 05:04 PM
    • Replies: 2
    • Views: 91
    13th October 2014 05:15 AM Go to last post
  15. Futaba T8UAP Issues

    Does anyone out there know how to set up the 3 position switch in the NAZA V2 Assistant on the Futaba T8UAP. I set up channel 7 to the U port on the...

    Started by TOPGEE‎, 12th October 2014 11:04 AM
    • Replies: 0
    • Views: 67
    12th October 2014 11:04 AM Go to last post
  16. FRsky glitching

    hi all, my first post. flying fpv today i went out around 700 meters over fields and over the top of a hotel (100)meters up or so (this hotel is...

    Started by jesus christ‎, 8th October 2014 04:15 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 372
    12th October 2014 04:17 AM Go to last post
  17. T8J rudder channel to control aux switch instead of rudder help?

    hi guys so, i have a t8j that i have hooked up to ezuhf 4ch rx for a wing project. channels1 & 2 for elevons, ch3 for throttle and ch4 i'd like...

    Started by nowler‎, 11th October 2014 05:37 PM
    • Replies: 0
    • Views: 64
    11th October 2014 05:37 PM Go to last post
  18. Cleaning up FPV wiring

    This thread will be for tips, tricks, and pics of clean fpv wiring. I personally am interested in how people do the connections between a wing,...

    Started by Rfriedman‎, 29th September 2014 11:35 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 985
    11th October 2014 05:44 AM Go to last post
  19. TBS Discovery Pro with ezUHF using Futaba T14SG

    I bought a TBS Discovery Pro with ezUHF Diversity 8 channel receiver. I already owned a Futaba T14SG and want to set it up to use with the Discovery...

    Started by tlgreen58‎, 28th June 2014 07:02 PM
    futaba 14sg
    • Replies: 1
    • Views: 181
    10th October 2014 07:35 PM Go to last post
  20. Brotronics PowerTower OpenLRSng Receiver problem.

    I bought 2 PowerTower receivers from MultiRotor Super Store, because they seemed like a pretty cool concept, but I am having the same problem with...

    Started by JP1‎, 4th October 2014 10:29 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 446
    10th October 2014 01:22 PM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts