FPVLAB

image
  1. Announcement:
    SUPPORT MODEL AVIATION!!!
    FPVLAB ‎(Tha Bawss)
    24th February 2011
    Views:
    31,882
+ Post New Thread
Page 1 of 127 1 2 3 11 51 101 ... LastLast
Threads 1 to 20 of 2539

Forum: RC TECH

(??s about your control, receivers, ESCs, batteries or tech help)

  1. Sticky Thread Sticky: Official Connector Thread

    Sentry could you please Sticky this? I've seen the question asked many a time, for connectors and where to get them, I figured why not start and...

    Started by injector‎, 8th October 2012 12:27 AM
    16 Pages
    1 2 3 ... 16
    • Replies: 154
    • Views: 34,823
    2nd March 2015 04:41 PM Go to last post
  2. Sticky Thread Sticky: 2.4ghz Control Megathread - Spektrum, Futaba, FrSky, etc

    Thanks to my brother I was able to do some extensive range testing with my DX8 radio. He lives on a smallish inland lake in MI, so while I had...

    Started by aeryck‎, 22nd August 2011 11:23 AM
    24 Pages
    1 2 3 ... 24
    • Replies: 237
    • Views: 38,889
    9th February 2015 10:00 PM Go to last post
  3. Sticky Thread Sticky: LETS TALK CHARGERS

    Time to upgrade to a decent multiple-charger (lipo) since my bigger models run 5000mAh or bigger. I'd like to be able to charge 1 - 4 lipos...

    Started by SENTRY‎, 24th September 2011 02:07 AM
    19 Pages
    1 2 3 ... 19
    • Replies: 182
    • Views: 17,835
    26th December 2014 03:56 PM Go to last post
  4. Sticky Thread Sticky: Lipo break-in: The how, why, and benefits of a DIY discharger

    I've been doing a lot of reading on lipos recently and one thing that stuck out was how a few people were breaking in their batteries. Up until now...

    Started by PnoT‎, 9th May 2011 02:48 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 24,287
    29th April 2014 06:34 PM Go to last post
  1. Question Spektrum recommendation please ?

    I am building a mini quad for a friend who has a spektrum dx6i. What would be the best RX for a mini quad ? I have frsky gear and know bugger all...

    Started by j45on‎, 3rd March 2015 04:32 PM
    • Replies: 2
    • Views: 39
    3rd March 2015 07:00 PM Go to last post
  2. Help me not burn up this esc motor combo please!

    Hello everyone. What I've got is some kiss 18a escs, and some multirotormania mini Titan 2204 2300kv motors. I've also got a naze32 acro, ...

    Started by la1z24‎, 12th January 2015 09:10 AM
    • Replies: 9
    • Views: 320
    3rd March 2015 06:56 PM Go to last post
  3. Are there TX like the Phantom TX

    I am doing my first build and I'm coming from the dji Phantom world. I will need to buy a new controller. I have gotten use to the Phantom controller...

    Started by sundance2013‎, 28th February 2015 06:21 PM
    3 Pages
    1 2 3
    • Replies: 27
    • Views: 759
    3rd March 2015 06:39 PM Go to last post
  4. Plugs for Tiger motor S25A ESC needed

    Hello, I have bought the Tiger motor MN3510-25 360KV with 60cm cables and the T-motor S25A ESC. I have trimmed the wires and wanted to unsolder the...

    Started by Papa Echo‎, 1st March 2015 08:41 PM
    • Replies: 1
    • Views: 53
    3rd March 2015 06:31 PM Go to last post
  5. Do I need to retune when switching between 3S and 4S?

    Howdy, I'm running a Naze32 with the latest CF (1.7.2) on a BAH Mini (HQ645, Cbr 2208 2000kv, KISS 18A). It flies super smooth on 3S but gets a...

    Started by HarryHastur‎, 3rd March 2015 05:16 PM
    • Replies: 0
    • Views: 6
    3rd March 2015 05:16 PM Go to last post
  6. Question question regarding antennas and ground

    so i have a full CF frame which i know is conductive. i want to install three antennas on this frame using the female rpsma connector, however these ...

    Started by bagofsoup‎, 3rd March 2015 12:37 PM
    • Replies: 0
    • Views: 61
    3rd March 2015 12:37 PM Go to last post
  7. i'm looking for FPV expert (need to build FVP for volunteer project)

    Hi, i'm looking for FPV expert to help with volunteer project. I've found platform for the project - RVJET Flying Wing Platform 2014 now i need...

    Started by valeravl‎, 27th January 2015 06:03 PM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 1,100
    3rd March 2015 11:11 AM Go to last post
  8. What RX to use with the Turnigy DSSS 2.4Ghz Transmitter Module For 9XR

    <!--><xml> <o:OfficeDocumentSettings> <o:AllowPNG/> </o:OfficeDocumentSettings> </xml><!-->Hi all, what rx would you suggest I use with the ...

    Started by quadraman‎, 3rd March 2015 05:56 AM
    • Replies: 0
    • Views: 27
    3rd March 2015 05:56 AM Go to last post
  9. Conformal Coating your boards?

    With a the chance of weather changing before you can retrieve your craft that has exposed electronics, have any of you use conformal coatings to...

    Started by metoo‎, 25th October 2014 10:56 AM
    • Replies: 6
    • Views: 283
    2nd March 2015 06:39 PM Go to last post
  10. Anyone using the Lidar lite?

    Hi all, Is anyone using the Lidar lite? https://www.sparkfun.com/products/13167 How do you like it? Any complaints? Thanks much,...

    Started by zoom99‎, 23rd February 2015 06:58 PM
    • Replies: 4
    • Views: 191
    1st March 2015 10:41 PM Go to last post
  11. Frsky X8R Receiver Antenna Mounting

    Hi there! I recently acquired a new X8R receiver and I was curious on how people were mounting the receiver antennae on their aircraft. Currently,...

    Started by matau1003‎, 10th February 2015 03:46 PM
    • Replies: 7
    • Views: 406
    1st March 2015 07:47 PM Go to last post
  12. What is the tape that holds the heat sink onto ESC?

    I was working on my ESC when this part came off, I think it is an aluminum heat sink held on with double sided tape. I wanted to put new tape on...

    Started by noishi‎, 1st March 2015 02:03 PM
    • Replies: 3
    • Views: 65
    1st March 2015 04:57 PM Go to last post
  13. dual operator solutions

    Hey guys I've tried searching for other threads on setting up a dual operator setup I'm sure I'm just missing it. Anyways i'm curious before I go...

    Started by DaveTheWhiteAsian‎, 1st March 2015 04:20 PM
    • Replies: 0
    • Views: 50
    1st March 2015 04:20 PM Go to last post
  14. Taranis receiver questions

    New to the Taranis and have a couple of basic questions. (Sorry if these have been asked many times - couldn't find the answers) -Do all the...

    Started by schmitty‎, 15th February 2015 01:53 PM
    • Replies: 4
    • Views: 559
    28th February 2015 07:07 PM Go to last post
  15. Taranis LUA scripting...anybody doing this?

    I'm taking a crack at some telemetry scripts and I'm having some difficulty understanding how to run them in the OpenTX Companion simulator. Anybody...

    Started by JammerX19‎, 28th February 2015 04:44 PM
    • Replies: 0
    • Views: 69
    28th February 2015 04:44 PM Go to last post
  16. Solderless Programmer Board for Turnigy 9x

    Has anybody had any luck with this? http://www.smartieparts.com/shop/index.php?main_page=product_info&cPath=3&products_id=331 Ive gotten to the...

    Started by Outdoorz‎, 19th February 2015 07:54 PM
    • Replies: 4
    • Views: 152
    28th February 2015 02:55 PM Go to last post
  17. First post: taranis plus naza m lite throttle power low. Mxp230 sluggish

    I have taranis plus. Dr4ii. Naza m lite. PPM. Xhover mxp230. May ask for your advice please? Issue: with throttle increasing throttle after initial...

    Started by Wolfy1970‎, 24th February 2015 05:40 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 301
    28th February 2015 02:33 AM Go to last post
  18. Red face OpenLRSng TX/RX from HawkEye

    Hi, is anybody using this equipment? I've got the Futaba 1W Tx module plus 8-ch 100 mW Rx. (Ordered mine from AeroQuad.) I haven't had mine in...

    Started by crashy‎, 19th November 2013 03:15 PM
    47 Pages
    1 2 3 ... 47
    • Replies: 462
    • Views: 61,433
    27th February 2015 01:52 AM Go to last post
  19. Question Single Stick Transmitter, how?

    For some strange reason I'm having this strange desire to keep similar controls grouped in pairs to my hands which I guess is coming from me handling...

    Started by Durahl‎, 25th February 2015 02:34 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 397
    26th February 2015 06:08 PM Go to last post
  20. Acro Naze32 PPM RC input pad came off

    Has anyone had an issue of an RC input pad coming completely off on their naze32 board? My friend just had his #1 pad come off after he soldered it....

    Started by ThisIs84‎, 25th February 2015 05:30 PM
    • Replies: 2
    • Views: 62
    26th February 2015 05:39 PM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts